BUCKET AR-MULTIPURPOSE 3187248 - Caterpillar

Ethernet Configuration
Note: Each MMU requires the following procedures.
Illustration 1 g01273567
PC Settings and Connection settings
Place the system into Bypass mode by turning the keyswitch to the Bypass position.
Click "PC Settings/Connection Settings" on the toolbar.
Connect to a computer that is equipped with "UPSView". Connect to the RS 232 port in the system cabinet.
Select the appropriate MMU. Select the MMU with the Selector Switch on the Parallel Cabinet Interface (PCI).
Illustration 2 g01273569
"UPSView" Connection Settings
Click "Connect" on the "Connection Menu".
Illustration 3 g01273571
Connect to "UPSView"
Click "Enter Password" on the Main Tool Bar.
Enter the User name and the password in the "Enter Password Screen".
Illustration 4 g01273572
User Name and Password Entry Screen
Click "OK".Note: To change the "Network Enable" parameter, a special password must be obtained from Active Power.
Click "OP. Params \ OP Group 5 Internal CAN Enable \ Network Enable" on the Main Toolbar.
Change the default 0 to 1.
Click "Send".
Press "Y" in order to confirm the reset of the processor.Enabling of the Ethernet Options is now complete.Note: Wait for reboot before attempting to continue.
Click "UPSView Settings".
Click "Remote Notification Settings" from the "UPSView Settings" Menu.
Illustration 5 g01273593
Enable the Network Drop-Down Menus.
Illustration 6 g01273594
Enable Network Screen.
Illustration 7 g01273595
Settings Drop-Down Menus.
Click "Network Configuration" from the Remote Notifications Menu.
Illustration 8 g01273596
Network Configuration Screen.
Enter Network Information in the Network Configuration Screen. See your system administrator for Network Information.
Click "Send" Button. Text will appear on the Text Box Window Stating "Accept / Decline".
Click "Receive" in order to verify the Network Settings.
Close the screen.
Press "CTRL-R" in order to Reset the processor.
Press "Y" in order to acknowledge the Reset of the Processor.Note: Default Gateway: Revision E SNMP must be enabled to use this feature.