BUCKET AS-GENERAL PURPOSE 3377417 - Caterpillar

Illustration 16 g00847581
Position carrier (30) on impeller wheel (25) .Note: The ball should be lined up with the groove in the bearing.Note: Do not damage the seals during assembly.
Use Tooling (D) in order to install carrier (30) in impeller wheel (25) .
Illustration 17 g01362340
Illustration 18 g00837297
Turn over impeller wheel (25). Install two guide bolts. Place stator (28) on the impeller wheel and install bolts (27). Tighten bolts (27) to a torque of 40 5 N m (30 4 lb ft).
Illustration 19 g03748598
Turn over impeller wheel (25). The weight of impeller wheel (25) with the carrier is approximately 30 kg (65 lb). Install Tooling (C) and a suitable lifting device onto impeller wheel (25). Place impeller wheel (25) with the carrier on the housing. Remove Tooling (C) .
Install bolts (19). Tighten bolts (19) to a torque of 51 N m (37 lb ft).
Illustration 20 g00837282
Raise bearing race (23) to a temperature of 135 °C (275 °F) for ten minutes. Install the bearing race on shaft (21) .
Install seal ring (24) on shaft (21) .
Raise bearing (22) to a temperature of 135 °C (275 °F) for ten minutes. Install the bearing on shaft (21). Apply clean SAE 30W oil to seal ring (24). Pull the ends of the seal ring together.
Illustration 21 g01216087
Illustration 22 g01216218
Install shaft (21) and the bearing in the torque converter.Note: Do not damage the seals during assembly.
Use Tooling (C) in order to install retaining ring (20) .
Install O-ring seal (18) on the carrier. Apply clean SAE 30W oil to the seal.
Illustration 23 g03748527
Install lip seal (17) in the carrier with the lip of the seal toward the bearing. Apply clean SAE 30W oil to the lip of the seal.
Install Tooling (A) on cover (16) and attach a suitable lifting device. The weight of cover (16) is approximately 70 kg (150 lb).
Use Tooling (B) in order to install cover (16) on the torque converter. Make sure that the O-ring seal stays in position when you install the cover.
Illustration 24 g00850466
Install bolts (14). Tighten bolts (14) to a torque of 50 7 N m (37 5 lb ft).
Install yoke (13). Install sensor (12). Install retainer (11) and bolt (10). Tighten bolt (10) to a torque of 105 15 N m (77 11 lb ft).
Illustration 25 g00533430
Place bearing (5) in planetary gear (6). Place one washer (9) on each side of planetary gear (6), and place the components in the planetary carrier. Install shaft (7) .
Align the hole in shaft (7) with the hole in the planetary carrier. Install pin (8) even with the surface of the planetary carrier.
Illustration 26 g00533624
Install retaining ring (3) in the inner diameter of planetary carrier (2). Position retainer (4) next to the spiral ring.
Illustration 27 g00495910
Position planetary carrier (2) in the ring gear and on the shaft. Make sure that the retainer stays in place.
Install retaining ring (1) .End By: Install the torque converter.