BUCKET AS-MATERIAL HANDLING 3697499 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 8T-3207 Lifting Bracket 1
5P-8622 Shackle 1
6V-9667 Bolt 2
9S-9076 Spacer 2
Illustration 1 g00747076Note: O-rings, gaskets, and seals should always be replaced. A used O-ring may not have the same sealing properties as a new O-ring. A reconditioning procedure should not be degraded because of a low cost component such as an O-ring or a gasket. Use 1U-6396 O-Ring Assembly Compound during the assembly procedure.
Put O-ring seals (8) and (9) in position on the housing.
Illustration 2 g00743488
Illustration 3 g00743489
Fasten a suitable lifting device and Tooling (A) to final drive (5).
Put the steering clutch and brake assembly in position in the main frame case. Install bolts (4) and (7).
Remove Tooling (A).
Illustration 4 g00745347
Install two bolts (2).
Install sprocket segment (1). Torque the bolts to 175 40 N m (130.0 30.0 lb ft). Torque the bolts again to 380 N m (280.0 lb ft). Note: Refer to the Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities" for all fluid capacities and the proper filling procedures.
Fill the final drive with oil to the correct level. End By:
Install the axles. Refer to Disassembly and Assembly, "Axle - Remove and Install".
Connect the tracks. Refer to Disassembly and Assembly, "Track - Connect".