BUCKET GP-GENERAL PURPOSE 3953265 - Caterpillar

Illustration 1 g02567539
Schematic of the position sensor (Bowl control)This diagnostic code is associated with the Position Sensor (Bowl Control). The FMI 04 means that the ECM has determined that the voltage of the circuit for the position sensor is below normal.The output frequency of the position sensor is approximately 500 Hz. The duty cycle of the signal changes as the position sensor moves.Bowl Raise - 5 percent to 35 percent duty cycleBowl Neutral - 40 percent to 60 percent duty cycleBowl Lower - 65 percent to 95 percent duty cycleThe possible causes of this diagnostic code are listed below:
The signal circuit for the sensor is shorted to ground.
The sensor has failed.
The ECM has failed. The failure of ECM is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1281 FMI 04 is active before performing this procedure. Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code occurs, a warning (Category 1) is shown on the monitor. The diagnostic code will cause the solenoids for the bowl control to be set to the minimum command. Control of the bowl will not return until the diagnostic code is inactive. The signal from the position sensor must be in the neutral position for at least 2 seconds.Test Step 1. CHECK THE SENSOR
Turn the disconnect switch