BUCKET AR-GENERAL PURPOSE 4174359 - Caterpillar

Hydraulic System
Dry nitrogen is the only gas approved for use in the accumulators. The charging of oxygen gas in an accumulator will cause an explosion. An explosion can be eliminated by using nitrogen gas cylinders with standard CGA (Compressed Gas Association, Inc.) No. 580 connectors. When nitrogen gas is ordered, make sure to order the cylinders with CGA No. 580 connectors.Do not rely on color codes or other methods of identification to tell the difference between nitrogen and oxygen cylinders. In any application, never use an adapter to connect your nitrogen charging group to a valve outlet used on both nitrogen, oxygen, or other gas cylinders. BE SURE YOU USE DRY NITROGEN (99.8% purity).
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Escaping fluid under pressure, even a pinhole size leak, can penetrate body tissue, causing serious injury, and possible death. If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.Always use a board or cardboard when checking for a leak.
Cylinders equipped with load control valves can remain pressurized, even with hoses removed.Failure to relieve pressure before removing a load control valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a load control valve or disassembling a cylinder.
Sudden movement or accidental starting of the machine can cause personal injury or death to persons on or near the machine.To prevent personal injury or death, perform the following:Park the machine on a smooth, level surface.Lower the work tool to the ground and engage the parking brake.Stop the engine and remove the key.Block the wheels and install the steering frame lock.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Introduction
The following procedure is used in order to relieve hydraulic pressure in the system.Required Tools
Tools are not required for this procedure.Machine Preparation
Move the machine to a smooth, horizontal location. Move the machine away from other operating machines and away from personnel. Place the transmission direction control switch in the NEUTRAL position. Engage the parking brake and put chocks in front of the wheels and behind the wheels.
Lower the scraper bowl to the ground.
Shut off the