BUCKET GP-MATERIAL HANDLING 4533770 - Caterpillar

4533770 BUCKET GP-MATERIAL HANDLING Caterpillar parts 982M

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4533770
453-3770
4533770

Caterpillar 4533770 BUCKET GP-MATERIAL HANDLING

Buy BUCKET GP-MATERIAL HANDLING 4533770 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL LOADER,

Compatible equipment models: 4533770:

WHEEL LOADER 982M Caterpillar

Number on catalog scheme:

Caterpillar 4533770 Parts scheme BUCKET GP-MATERIAL HANDLING

For full view, you need register

Information:

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-1857 Retaining Ring Pliers 1
B 1U-6683 Ring Expander 1 Start By:
Remove the pistons and connecting rods. Refer to Disassembly and Assembly, "Pistons and Connecting Rods - Remove".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Make a temporary mark on the components of the piston and connecting rod assembly. This will ensure that the components of each piston and connecting rod assembly can be reinstalled in the original cylinder. Mark the front of the piston and the front of the connecting rod. Do not interchange components.
Illustration 1 g01311807
Typical example
Place the piston and connecting rod assembly on a suitable surface with the connecting rod upward. Use Tooling (A) in order to remove retaining rings (4).
Remove piston pin (3) and connecting rod (1) from piston (2). Note: If the piston pin cannot be removed by hand, heat the piston to a temperature of 45 5 °C (113 9 °F). Do not use a torch to heat the piston.
Illustration 2 g00829406
Typical example
Illustration 3 g01311809
Place the piston on a suitable surface with the crown upward. Use Tooling (B) in order to remove compression rings (5) and (6), and oil control ring (7) from piston (2). Note: Identify the orientation of the piston rings for installation.
Illustration 4 g01311837
Typical example
Remove nuts (11) and connecting rod cap (10) from connecting rod (1).
Remove the lower half of connecting rod bearing (9) from connecting rod cap (10). Remove the upper half of connecting rod bearing (8) from connecting rod (1). Keep the bearing shells together.
Removal of the piston pin bushing in the connecting rod must be carried out by personnel with the correct training. Also special machinery is required. For more information refer to your authorized Caterpillar dealer.
Inspect the connecting rod for wear or damage. If necessary, replace the connecting rod or replace the bush for the piston pin.