BUCKET GP-HOE 4649911 - Caterpillar

Illustration 5 g01364668
Attach a suitable lifting device to rear sweep assembly (4). Remove bolts (5), washers (6), and retainers (7) .
Remove rear sweep assembly (4). The weight of rear sweep assembly (2) is approximately 56 kg (124 lb).
Illustration 6 g01364695
If necessary, remove bolts (10) and the washers from front sweep assembly (2). Remove supports (9) and mounts (8) .
Illustration 7 g01364703
If necessary, remove mounts (11) from rear sweep assembly (4) .Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     138-7574     Link Bracket     2    
B     140-7742     Sleeve     2    
C     1U-9200     Lever Puller Hoist     1    
E     5P-3975     Rubber Lubricant     1    
Illustration 8 g01364703
If necessary, install mounts (11) into rear sweep assembly (4) .
Prior to installation, apply Tooling (E) to mounts (11) .
Illustration 9 g01364695
If necessary, install mounts (8) and position supports (9). Install the washers and bolts (10) into front sweep assembly (2). Tighten bolts (10) to a torque of 125 20 N m (92 15 lb ft).
Prior to installation, apply Tooling (E) to mounts (8) .
Illustration 10 g01364638
Illustration 11 g01364668
Attach a suitable lifting device to rear sweep assembly (4). Position rear sweep assembly (4). The weight of rear sweep assembly (2) is approximately 56 kg (124 lb).
Install retainers (7), washers (6), and bolts (5). Remove any suitable lifting devices.
Illustration 12 g01364783
Attach Tooling (A) and a suitable lifting device to front sweep assembly (2) .
Illustration 13 g01364618
Illustration 14 g01364638
Attach Tooling (C) to the suitable lifting device. Attach Tooling (B) to Tooling (C) .
Attach Tooling (B) and a suitable lifting device to front sweep assembly (2). Repeat on the other side.
Position front sweep assembly (2). Install bolts (3) onto both sides of the machine. The weight of front sweep assembly (2) is approximately 125 kg (275 lb).
Illustration 15 g01364782
Install the washers and bolts (1). Tighten bolts (1) to a torque of 125 20 N m (92 15 lb ft). Remove Tooling (A) and any suitable lifting devices.