BUCKET AS-MATERIAL HANDLING 5068642 - Caterpillar

Illustration 3 g01053977
Install spacer plate (12) on the dowels.
Check the cylinder liner projection. Refer to Testing and Adjusting, "Cylinder Liner Projection" for the correct procedure.
Illustration 4 g01053975
Install new seals (9) and (10) in the spacer plate.
Install a new O-ring seal (11) on the dowel.
Ensure that the bottom of the cylinder head assembly is thoroughly clean.
Illustration 5 g00618255
The plug for Location (C) MUST be installed in the cylinder head.
Install Tooling (A) into the threaded holes for the valve cover base in the cylinder head. Attach a suitable lifting device to Tooling (A).
Illustration 6 g01053935Note: The weight of cylinder head assembly (7) is approximately 47 kg (104 lb).
Install a new head gasket (8). Lift cylinder head assembly (7) into position on the cylinder block. Install bolts (6) and (1) according to the instructions in Step 11, Step 12, or Step 13.Note: Only 216 mm (8.5 inch) bolts (6) can be used for the following torque procedures.Note: Refer to Specifications, "Cylinder Head".
Illustration 7 g06344184
Tightening sequence with 362-8264 Cylinder Head Gasket (MLS) and 519-7297 Spacer Plate (Iron).Note: Refer to Illustration 7 for the correct tightening sequence.
Coat the threads of the bolts with clean engine oil.
Tighten bolt (1) through bolt (8) to a torque of 30 5 N m (22 4 lb