BUCKET GP-MULTIPURPOSE 5360035 - Caterpillar

Illustration 1 g06240573
Typical example
Table 1
Item Qty Part Specification Description
2 - 137-8856 Pin Use the following procedure to assemble cover (1) and pin (2) without shims:
1. Assemble cover (1) and pin (2) without shim pack (4).
2. Tighten bolts (5) lightly to remove end play.
3. Measure maximum gap between cover and axle housing surface.
4. Select and install shim thickness to provide −0.03 mm (−0.001 inch) (preload) to 0.03 mm (0.001 inch) (end play) in pin.
Total thickness of 154-7997 Shim Pack (4) is 4.88 0.30 mm (0.192 0.012 inch)
Diameter of pin (2) is 34.87 34.92 mm (1.373 1.375 inch).
3 - 140-6555 Bushing Bore diameter is 50.920 0.013 mm (2.0047 0.0005 inch).
6 24 6V-3532 Bolt Use the following procedure in order to tighten the bolts:
1. Torque to 210 40 N m (155 30 lb ft).
2. Turn bolts to an additional angle of 120 10 degrees.
7 24 160-8510 Self-Locking Bolt Use the following procedure in order to tighten the bolts:
1. Torque to 130 30 N m (96 22 lb ft).
2. Turn bolts to an additional angle of 120 10 degrees.
8 1 136-8033 Bevel Gear Set Assembled backlash is 0.40 0.12 mm (0.016 0.005 inch).
9 4 Bolt Torque to 1800 200 N m (1328 148 lb ft).
10 16 397-9376 Bolt Use the following procedure in order to tighten the bolts:
1. Torque to 230 30 N m (170 22 lb ft).
2. Turn bolts to an additional angle of 120 10 degrees.
11 29 178-2991 Self-Locking Bolt Use the following procedure in order to tighten the bolts:
1. Torque to 230 30 N m (170 22 lb ft).
2. Turn bolts to an additional angle of 120 10 degrees.
12 16 8T-0650 Bolt Torque to 300 30 N m (222 22 lb ft).