BUCKET GP-ADJ& 5432823 - Caterpillar

Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     4C-4892     ORFS Fittings Group     1    
4C-9910 Flow Meter
48200 kPa (7000 psi)
13 L/min to 473 L/min (4 US gpm to 125 US gpm)     1    
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the implement hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00772062
(1) Hose assembly to the rotate circuit (right)
Disconnect hose assembly (1) from the adapter assembly on the rotator of the work tool.
Install Tooling (A) in either direction between hose assembly (1) and the adapter assembly on the rotator.
Start the host machine. Run the host machine at high idle and operate the implements until the hydraulic oil reaches normal operating temperature.
Rotate the work tool. Ensure that the direction of the rotation corresponds with the direction of flow of Tooling (A). Record the reading on the flow meter. The flow meter reading should be 20 5 L/min (5.3 1.3 US gpm). If the flow is not within the specification, the