BUCKET GP-CPLR 5509445 - Caterpillar

Windshield Wiper (5) - Move the switch to the right to actuate the wipers. Move the switch to the left to stop the wipers. Windshield Washer (6) - Move the switch to the right to spray window washing solvent onto the windshield. The switch goes back to OFF when released.Horn
Horn - Push the switch down to sound the horn. Release to stop. Use the horn to signal or alert people nearby.Travel Alarm (If Equipped)
Travel Alarm - The alarm sounds anytime either the forward or reverse travel pedal is depressed.Press the button at the top of the steering control lever to stop the alarm when it is not required.The travel alarm, located under the rear of the upper structure, sounds to alert people nearby of machine movement.When the button is depressed momentarily while traveling, the alarm will sound for 10 seconds, then it will turn off.It will remain off until the machine is stopped and travel is resumed in either direction.Interior Dome Light
Dome Light - Move the switch to turn the inside cab light on or off.Fan - Circulating (If Equipped)
Move the switch (1) to the uppermost position for HIGH fan speed. The middle position is OFF. Move the switch to its lowest position for LOW fan speed.Before repositioning fan, move the switch to OFF and allow fan blades to stop.1. Loosen bolt (2).2. Reposition fan as desired.3. Tighten bolt.Lighter
Lighter - Push the lighter knob down to activate.Heater Control Switch (If Equipped)
Turn the knob for the desired amount of heat.Heating and Air Conditioning Controls
Air Conditioner Temperature (1) - Turn the switch clockwise for more cooling or counterclockwise for less cooling. The fan switch must be in the air conditioning range. Fan (2) - Turn the switch clockwise to one of three fan speeds for heat. Turn the switch counterclockwise to one of three fan speeds for air conditioning. Heater Temperature (3) - Turn the switch clockwise for more heat or counterclockwise for less heat. The fan switch must be in the heat range.Keep rags or objects away from the air inlet opening of the air conditioner. They can restrict air flow.Windshield
Falling windows can cause personal injury.To prevent windows from falling on the operator, be sure the latches at the top of the cab hold the windows securely.
1. The front and sliding back windows (if equipped) can be opened to provide ventilation. The windows can also be used for secondary exits if the door is blocked. 2. Unlatch the window on each side.3. Lift the window until it latches at a desired opening. 4. Unlatch the upper window on each side for increased air flow. 5. Swing the windows up to the cab roof.Be sure the latches on the roof hold the window in place.6. The upper window can be opened while the lower window remains in place.Sliding Rear Window (If Equipped)
Unlatch the rear window and loosen the lock knob to move it.Cab Door
Open the door and swing it back until it latches in the open position. Move