BUCKET AR 5662007 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     311-1362     Vacuum Gauge     1    
B     185-3630     Strap Wrench As     1    
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all hose assemblies for installation purposes. Plug all hose assemblies and ports. This helps to prevent fluid loss, and this helps to keep contaminants from entering the system.
Install Tooling (A) onto the hydraulic tank. Attach an air supply hose onto Tooling (A). Apply 138 kPa (20 psi) of air. This procedure will pull a vacuum on the hydraulic system.
Illustration 1 g01528743
Open hood (1) and open door assembly (2) .
Illustration 2 g01528749
Disconnect hose assemblies (6) and hose assembly (7) .
Use Tooling (B) in order to remove oil filter (8) .
Remove bolts (3) and remove filter base (5). Remove valve assembly (4) and the O-ring seals.Installation Procedure
Table 2
Required Tools    
Tool     Part Number     Part Description     Qty    
A     311-1362     Vacuum Gauge     1    
B     185-3630     Strap Wrench As     1    Note: Cleanliness is an important factor. Before installation, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g01528749
Install the O-ring seals onto valve assembly (4). Install valve assembly (4) into filter base (5). Tighten valve assembly (4) to a torque of 49 5 N m (36 4 lb ft).
Position filter base (5) and install bolts (3). Tighten bolts (3) to a torque of 15 3 N m (11 2 lb ft).
Use Tooling (B) in order to install filter (8). Connect hose assembly (7) and hose assemblies (6) .
Illustration 4 g01528743
Close hood (1) and close door assembly (2) .
Release vacuum and remove Tooling (A). Check the hydraulic level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".