BULLDOZER AR 8E2277 - Caterpillar

Removal Procedure
Start By:
Remove the cab. Refer to Disassembly and Assembly, "Cab - Remove".
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Drain the hydraulic oil into a suitable container. The capacity of the hydraulic tank is 38 L (10 US gal).
Illustration 1 g00755957
Loosen clamp (1) and (2). Disconnect hose (3) and (4) .
Remove four bolts (5) .
Illustration 2 g00755958
Loosen clamp (6) and disconnect hose (7) .
Illustration 3 g00755960
Loosen clamps (9) and (10). Disconnect hoses (11) and (12). Loosen clamp (13) and disconnect hose (14) .
Remove the hydraulic tank assembly (8) .