BUMPER-CONICAL 3W7412 - Caterpillar

Disassembly Procedure
Start By:
Remove the control manifold. Refer to Disassembly and Assembly, "Control Manifold - Remove". Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01344304
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Remove bolts (1), retainers (2), and solenoids (3) from control manifold (4).
Remove plugs (7), O-ring seals (6), springs (8), and poppets (5).
Illustration 2 g01344346
Remove O-ring seals (9) from solenoids (3).