BUMPER AS 4152016 - Caterpillar

Rework Procedure
Table 1
Required Parts    
Quantity     Part Number     Description    
1     5N-2840     Clip    
1     8T-4177     Bolt    
1     5P-4116     Hard Washer    
2     7X-0613     Hard Washers    
Raise the hood.
Illustration 1 g00850971
Remove the existing retaining clip. Install 5N-2840 Clip (1) on 179-9342 Hose As. Position the hose assembly and the retaining clip toward the center of radiator (2) .
Use one 8T-4177 Bolt, one 5P-4116 Hard Washer and two 7X-0613 Hard Washers in order to install the retaining clip to the oil cooler. Do not tighten the retaining clip at this time.
Illustration 2 g00850972
Inspect the angle of the bracket (3) that is located on the top of the radiator. There should be 2 mm (0.08 inch) to 6 mm (0.24 inch) between hose assembly (4) and the oil cooler. If necessary, adjust the hose assembly and the retaining clips.
Tighten the bracket and all of the retaining clips.
Close the hood. Check the alignment of the hose assembly. The hose assembly should pass through the center of the opening in the grill.