BUMPER AS 8X6258 - Caterpillar

Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g00524576
The transmission oil filter housing (1) is located on the top left side of the transmission case. The transmission oil filter housing (1) is located at the left rear of the tractor.
Park the machine on level ground. Apply the parking brake. Lower the bowl.
Clean transmission oil filter housing (1) .
Remove drain plug (3). Allow the oil to drain into a suitable container.
Remove bolt (2) from transmission oil filter housing (1) and remove the cover from transmission oil filter housing (1) .
Remove the used filter element and discard the used filter element.
Clean the inside of transmission oil filter housing (1) with a clean towel.
Insert a new filter element into transmission oil filter housing (1) .
Inspect the seal for the housing. Replace the seal if the seal is damaged.
Install the cover on transmission oil filter housing (1) .
Install drain plug (3) in transmission oil filter housing (1) .
Illustration 2 g00524574
The magnetic screen is located below the transmission oil filter. The magnetic screen is located at the front of the transmission housing.
Remove drain plug (6). Drain the oil into a suitable container.
Remove bolts (5) .
Remove cover (4) .
Remove the magnetic screen.
Separate the magnets from the screen. Wash the screen and the magnets in a nonflammable solvent.Note: Do not rap the magnets on hard objects. The magnets may be damaged. Replace damaged magnets.
Allow the cleaned parts to dry. Use compressed air in order to speed the drying of the parts.
Clean the magnets with a towel or clean the magnets with a stiff bristle brush.
Install the magnets into the screen.
Install the magnetic screen into the housing.
Install cover (4) and bolts (5) .
Install drain plug (6) .
Start the engine. Apply the parking brake.
Run the engine at low idle.
Check the filter for leaks. Check the magnetic screen for leaks.
Check the oil level of the transmission. Some oil may be needed. Add oil if oil is needed.
Shut off the engine.