BUSHING 0009184 - Caterpillar

Illustration 28 g01220886
Remove shims (15).
Illustration 29 g03742870
Use Tooling (C) and Tooling (L) in order to remove the rotary group.
Illustration 30 g00704450
Remove the rotary group from the housing.
Illustration 31 g00704455
Remove Tooling (B) and barrel (16).
Illustration 32 g00704494
Remove spring (17) from barrel (16).
Illustration 33 g00720503
Install spring (17) and shim (18) that was determined in Step 24 in barrel (16).
Illustration 34 g00704455
Install Tooling (B) in order to secure barrel (16).
Illustration 35 g00841804Note: Raise the temperature of housing (1) to 80 °C (176 °F). Lower the temperature of the rotary group.
Install the rotary group into the housing (1).
Illustration 36 g00706486
Remove Tooling (B).
Illustration 37 g01220886
Install shims (15).
Illustration 38 g01220884
Install O-ring seal (14).
Illustration 39 g00723542
Install cover (12). Use Tooling (A) in order to install retaining ring (11). Note: Pull the rotary group outward until the end stop is reached.
Illustration 40 g00848529
Install O-ring seal (4). Install flushing valve plate (5) in the position that was previously marked for reassembly.
Illustration 41 g00740130
Install head (3). Install bolts (2). Turn the shaft and tighten the bolts at the same time. Tighten bolts (2) to a torque of 48 N m (35 lb ft).
Illustration 42 g00848543
Install all the plugs into housing (1). End By:
Install the steering motor. Refer to Disassembly and Assembly, "Steering Motor - Install".