BUSHING-END 0676158 - Caterpillar

Function and Navigation Keys
Reference: For a full explanation of the use of the function keys and the navigation keys that are referenced in this section, refer to Systems Operation, "Electronic Control Module (Generator Set)"
Illustration 1 g02082653
(1) Display screen
(2) AC overview key
(3) Engine overview key
(4) Main menu key
(5) Acknowledge alarm key
(6) Event reset key
(7) Event log key
(8) Run key
(9) Auto key
(10) Stop key
(11) Escape/Return key
(12) Up key
(13) Right key
(14) "OK" key
(15) Down key
(16) Left keyInitial Setup
Information from the EMCP 4 is displayed on the display screen (1). Press the main menu key (4) in order to get to the main menu options.Press the "OK" key (14) in order to select one of the main menu options.The keypad is also used in order to change the set points. Press the "OK" key (14) in order to change a set point. Use the navigation keys in order to increase or decrease the value. Press the left navigation key (16) or the right navigation key (13) in order to change the digit that is to be adjusted.Note: The EMCP 4 panel will power up to the "MAIN MENU" screen.Set Points
Within each set point category there are one or more function blocks. Each of those function blocks may contain one or more set points. Each of the set point categories and the corresponding function blocks are shown below.Control
Automatic Start/Stop
Fuel TransferEngine Monitor/Protect
Battery Volt Mon
Crank Start/Stop Counters
Engine Cool Temp Mon
Engine Speed Mon
Enhanced Engine Mon
Service Maintenance IntervalEvents
Diagnostic Response Configuration
Engine Protection Response Configuration
Generator Protection Response Configuration
Custom Event Response Configuration
Other System Response ConfigurationGenerator Monitor/Protect
Enhanced Generator Monitor
Generator AC Monitor
Generator AC Power Monitor (EMCP 4.2 only)
Generator Over Current (EMCP 4.2 only)
Generator Over/Under Frequency
Generator Over/Under Voltage
Generator Reverse Power (EMCP 4.2 only)Network
RS-485 SCADAReduced Power Mode
There are no set points within this function blockProgram Trip Points
There are no set points within this function blockInput/Output (I/O)
Digital Inputs
Relay Outputs
Digital Outputs
Analog InputsMenu Maps
The maps in this section are to be used as a guide when programming the EMCP 4. Maps are provided for all versions of the controller.
Illustration 2 g03571636
EMCP 4.1
Illustration 3 g03572300
EMCP4.2
Programming the Display Preferences
The preferences affect the way data is viewed on the display screen. The configuration may need changed in order to meet local requirements.In order to program the display preferences, perform the following menu options.
Press the escape key (11) as many times as necessary in order to go back to the "MAIN MENU" screen. Or, press the main menu key.
From the "MAIN MENU", press the navigation keys in order to highlight the "PREFERENCES" option. The following parameters can be changed or viewed:
CONTRAST
PRESSURE
TEMPERATURE
VOLUME (EMCP 4.2 only)
CIRCUIT BREAKER SYMBOL
LAMP TEST
LANGUAGE
Press the "OK" key (14) in order to select "PREFERENCES". "CONTRAST" will be highlighted.
Press the "OK" key in order to select the contrast level. The contrast can be adjusted from low to high. The display will show a status bar representing the current contrast level.
Use the navigation keys in order to adjust the contrast to the desired level. Press the "OK" key (14) in order to save the new contrast setting.
Press the navigation keys in order to highlight