BUSHING GP-SEAL 1152440 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tooling Part Number Description Qty
A 1P-0510 Driver 1 Start By:
Separate the governor and governor drive. Refer to Disassembly and Assembly, "Governor and Governor Drive - Separate".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01000453
Remove seat (3), spring (2), and spring washer (1).
Illustration 2 g01000455
Remove retainer ring (4) from seat (5).
Illustration 3 g01000456
Remove dowel (6). Separate seat (5) from the weight assembly.
Illustration 4 g01000457
Remove washers (9), spring (7), and bolt (8) from seat (5).
Illustration 5 g01000458
Remove sleeve (10) and the bearing assembly from the cylinder and the weight assemblies.
Illustration 6 g01000459
Remove ring (11), races (13), and bearing (12) from sleeve (10).
Illustration 7 g01000460
Remove lockring (15) that holds weight assembly (16) to cylinder (14).
Remove weight assembly (16) from cylinder (14).
Illustration 8 g01000461
Remove valve (19), piston (18), and sleeve (17) from cylinder (14).
Remove O-ring seal (20) from sleeve (17).
Illustration 9 g01000462
Remove bracket (24) from housing (23).
Remove high idle screw (21), plug (22), and the gasket from housing (23).
Illustration 10 g01000465
Bend lock (28) away from bolt (25). Remove bolt (25) and lock (28).
Remove lever (26) and shaft (27) from the housing.
Use Tooling (A) in order to remove the plug and bearings (29) from housing (23).
Illustration 11 g01000466
Remove seal (30) from housing (23).