BUSHING 1154968 - Caterpillar

Table 1
MS952 Connector - 12 Pin Deutsch ("A" Key)
Pin Function
1 PWR +
2 PWR -
3 RS232-1 TXD
4 CAN1 H1
5 RS232-2 TXD
6 CAN2 HI
7 CAN2 LO
8 RS232-2 RXD
9 CAN1 LO
10 RS232-1 RXD
11 ID
12 Boot Monitor
Illustration 2 g06309524The serial lines go to pin 2 (RXD) and pin 3 (TXD) on the DB9 connector. It is recommended to have GND connected on pin 5 as well. If not properly grounded, serial connections may encounter further issues.
Table 2
RS232 (9 Pin Male)
Pin Function
1 DCD
2 RXD-
3 TXD
4 DTR
5 GND
6 DSR
7 RTS
8 CTS
9 RI
Illustration 3 g06309538Once this cable is built, download and install the Trimble Data Transfer software using the below link.https://www.trimble.com/datatransfer/
This needs the device settings to be configured. To configure the device settings, follow the below instructions.
Illustration 4 g06309567
On the computer, go to "Control Panel > Devices and Printers", and identify which COM port is being used for the serial connection. Note down this port number.
Illustration 5 g06309578
Open the Data Transfer utility, and select "Devices".
Illustration 6 g06309587
Select "New" in the "Devices" screen.
Illustration 7 g06309591
Select "GPS Receiver (R/SPS/5000 Series)" from the list of devices.
Illustration 8 g06309594
Select the COM port shown in Control Panel.
Illustration 9 g06309598
Enter a device name “MS95x”.
Illustration 10 g06309601
Select the settings shown below, then click the Next button until the setup prompts are completed.
Illustration 11 g06309611
On the Data Transfer screen, select “MS95x” and press the Connect button.
The files will be displayed in the "Files to Receive" list. Transfer all files off the receiver.After these files have been transferred, send the files to Caterpillar by submitting a DSN request for analysis.