BUSHING- 1301316 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A FT-2674 Vacuum Cap 1
B 138-7573 Link Bracket 2
C 1U-7505 Hydraulic Jack 1 Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01365595
Remove cover (1).
Illustration 2 g01365596
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 3 g01365597
Disconnect hose assemblies (2), (3), and (4). Remove support (5).
Illustration 4 g01365598
Attach Tooling (B) and a suitable lifting device to swivel (10). The weight of swivel (10) is approximately 45 kg (95 lb). Remove bolts (7) and retainer (9). Remove clamp (8) and boot (6).
Illustration 5 g01365599Note: The weight of guards (12) can increase due to debris on top of guards (12).
Position Tooling (C) under guards (12). Remove bolts (11) and guards (12). The weight of each guard (12) is approximately 25 kg (55 lb).
Illustration 6 g01365602
Disconnect hose assemblies (16). Disconnect fitting (17). Disconnect hose assemblies (13). Remove fittings (15). Remove bolts (14). Remove swivel (10).