BUSHING 1303139 - Caterpillar

Transmission:
TH55FT-E70 (S/N: PCJ1-UP)
Description of Change: A new improved torque converter inlet tube assembly that is more reliable is used with TH55 FT-E70 Petroleum Transmission.Replace the existing torque converter inlet tube assembly with the new improved torque converter inlet tube assembly. Refer to Table 1 for the new tube assembly and seals.Adaptable To: The new 371-2894 Tube As is a direct replacement for the former 304-3355 Tube As .The procedure is effective with the following machines:
TH55FT-E70 (S/N: PCJ1182)The procedure is adaptable to the following machines:
TH55FT-E70 (S/N: PCJ315-1181)Safety Section
Do not operate or work on this machine unless you have read and understand the instructions and warnings in the Operation and Maintenance Manuals. Failure to follow the instructions or heed the warnings could result in injury or death. Contact your Cat dealer for replacement manuals. Proper care is your responsibility.
Personal injury or death can result from improperly checking for a leak.Always use a board or cardboard when checking for a leak. Escaping air or fluid under pressure, even a pin-hole size leak, can penetrate body tissue causing serious injury, and possible death.If fluid is injected into your skin, it must be treated immediately by a doctor familiar with this type of injury.
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Required Parts
Table 1
Required Parts    
Item
Number     New
Part
Number     Description     Former
Part
Number     Qty    
1     7F-8267     O-Ring Seal         2    
2     228-7095     O-Ring Seal     8T-0315     2    
3     371-2894     Tube As     304-3355     1    Procedure to Install New Torque Converter Inlet Tube
Illustration 1 g02878857
Right side view
Illustration 2 g02881516
View of Area A (3) 304-3354 Tube As (4) Hose assembly (5) Block (6) Elbow assembly (7) Bolt (8) Clamp assembly (9) Tube assembly
Remove clamp assembly (8) between tube assembly (3) and tube assembly (9) .
Remove tube assembly (9) at the barrel nut and split flange.
Remove tube assembly (3) at the barrel nut and split flange.
Remove one end of hose assembly (4) from elbow assembly (6) .
Remove elbow assembly (6),