BUSHING 1624217 - Caterpillar

The fuse panel is located in the right side control console in the cab.
Electric Converter and Air Dryer (If Equipped) (1) - 10 amps.
Front Flood Lights (2) - 10 amps.
Rear Flood Lights (3) - 10 amps.
Transmission Shifter (4) - 10 amps.
Beacon (5) - 10 amps.
Autoshift (6) - 10 amps.
Rear Defroster (7) (If Equipped) - 10 amps.
Caterpillar Monitoring System Panel (8) - 10 amps.
Blank (9) - 10 amps.
Windshield Wipers (10) - 10 amps.
Lighter (11) - 10 amps.
Blank (12) - 10 amps.
Blade Kickout (13) - 10 amps.
Blank (14) - 10 amps.The fuse panel is located in the engine compartment on the right side of the machine.Open the lower engine compartment door and move the lever to open the upper engine compartment access door.
Stop Lights (15) - 10 amps.
Back-Up Alarm (16) - 10 amps.
Key Switch (17) - 10 amps.
Horn (18) - 10 amps.Reset Circuit Breakers
Circuit Breaker Reset - Push the button in to reset the circuit breakers. If working properly, the button will stay depressed. If the button does not stay in, or comes out shortly after being reset, have appropriate electrical circuit checked.Circuit Breaker for the fan motor and seat air compressor is located in the control console in the cab.
Seat Air Compressor (1) (If Equipped) - 15 amps.
Fan Motor (2) - 15 amps.Circuit Breakers are located in the engine compartment on the right side of the machine.Open the lower engine compartment door and move the lever to open the upper engine compartment access door. Alternator (3) - 80 amps. Main (4) - 80 amps. Windshield Wipers and WasherInspect/Replace
Inspect the front and rear windshield wiper blades. Replace if they are worn or damaged, or if streaking occurs.Fill Washer Bottle
When operating in freezing temperatures, use Caterpillar nonfreezing window washer solvent or equivalent. System damage can result from freezing.
Open the access cover located behind the operator compartment on the machine. The windshield washer fluid bottle is located in the center of the compartment. The bottle can be filled through the filler opening. Cutting Edge and End BitsChange or Replace
1. Raise and block the blade. Stop the engine. 2. Remove the cutting edge and end bits. Clean all contact surfaces. 3. Use the opposite cutting edge if it is not worn (end bits are not reversible). Use a new section if both edges are worn.4. Install all bolts and tighten them to the proper torque. See Torques for Ground Engaging Tool Bolts.5. Start the engine, raise the blade and remove the blocks.6. After a few hours of operation retighten all bolts to the proper torque. Tamping Tips (815F)Inspect or Replace
1. Inspect the tamping tips frequently. 2. Replace all tamping tips that have worn through to the wear cavity. Cleaner Bar (815F)Measure and Adjust
Measure the clearance between the scraper tip edges and the wheel. Correct clearance is 12 mm (1/2 in.). When the clearance reaches 25 mm (1.0 in.), adjust the scraper arms.To Adjust:
1. Loosen two bolts (1) and slide scraper arm (2) forward to the proper clearance.2. Tighten the nuts to 740