BUSHING 1K4441 - Caterpillar

Work Tool Positioner
IT38G Integrated Toolcarriers are equipped with two work tool positioners. The upper control group is used to set the detent position of an attachment such as forks or a broom. The lower control group is used to set the detent position of a bucket. The two adjustment procedures that follow are used in order to set the detent position of the corresponding work tool.
Illustration 4 g00933756
Tilt Cylinder with the Work Tool PositionerEnsure that the cover assembly for the work tool positioner is in the proper location on the tilt cylinder. The correct length for dimension (Y) is 820.4 5.0 mm (32.3 0.20 inch). If dimension (A) is correct, proceed to Step "Bucket Positioner". If dimension (A) is not correct, complete the following procedure.
Illustration 5 g00933781
(7) Bolts. (8) Clamp assembly.In order to adjust clamp assembly (8), loosen two bolts (7). Slide clamp assembly (8) on the tilt cylinder. Tighten bolt (7). Note: When you adjust the clamp assembly, ensure that the positioner switch is moved parallel to the magnet assembly during the movement on the cylinder. The clearance between the control group and the magnet assembly is 6 2 mm (0.24 0.08 inch). Positioner for the Bucket
Use caution to avoid possible personal injury when adjusting the attachment positioner.Stop the engine and lower all equipment to relieve the hydraulic pressure.Engage