BUSHING TRACK 1V4494 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     -     Guide Stud
(M 12 X 1.75 by 6 inch)     2    
B     1P-0520     Driver Group     1    
D     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01103652
Illustration 2 g01103673
Illustration 3 g01103806
Illustration 4 g01103675
Use Tooling (B) to install bearing (3) in flywheel housing (4) . The bearing joint is located at an Angle (XX) that is 15 3 degrees from the horizontal centerline. The oil hole in the bearing must align with the oil gallery in the flywheel housing. The bearing should extend beyond the surface of the flywheel housing by a Distance (YY) of 3.1 .5 mm (0.12 0.02 inch).
Install dowels (1) in flywheel housing (4) . The dowels should extend beyond the surface of the flywheel housing by a Distance (ZZ) of 3.5 .2 mm (0.14 0.01 inch).
Install thrust washer (2) into flywheel housing (4) .
Place adapter assembly (10) on the work surface. The outside face should be down. Install bearing (6) in adapter assembly (10) with Tooling (B) . The split in the bearing should be located at Angle (X) , which is 45 10 degrees from the centerline of adapter assembly (10) . The bearing should extend beyond the surface of adapter assembly (10) by a Distance (Y) of 3.1 0.5 mm (0.12 0.02 inch).
Install dowels (8) and thrust washer (7) in adapter assembly (10) . The dowels should extend beyond the surface of adapter assembly (10) by a Distance (Z) of 3.5 0.2 mm (0.14 0.01 inch).
Install O-ring seal (9) on adapter assembly (10) .
Use Tooling (D) to install lip seal (12) . Lubricate lip seal (12) lightly with the lubricant that is being sealed. Lip seal (12) should be installed to a depth of 2.5 0.5 mm (0.1 0.02 inch).
Install PTO shaft (5) and adapter assembly (10) into flywheel housing (4) and install bolts (11) . Ensure that the flat side of adapter assembly (10) is against the flywheel housing. This will ensure that the oil passage is located toward the flywheel housing.
Install bearing (15) in idler gear (14) with Tooling (B) . Bearing Relief Groove (V) must line up with Relief Groove (U) in idler gear (14) within 2 degrees. Bearing (15) must not extend beyond either face of gear.
Install idler gear (14) on idler shaft (18) and bolts (19) and (20) . Install the shaft and gear assembly in the flywheel housing.
Install Tooling (A) in the crankshaft. Install seal (16) and crankshaft gear (17) .
Install gasket (21) , cover (22) , and bolts (23) .End By: Install the crankshaft rear seal.