BUSHING 2094330 - Caterpillar

Illustration 1 g00760316
(A) Stick (B) BucketNote: Assemble this linkage on the machine by rotating the rod end of the bucket cylinder and by positioning the grease fitting away from the stick. Coat all of the bores for pins with lubricant. (1) 106-6877 Pin Diameter after plating ... 69.850 0.040 mm (2.7500 0.0016 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (2) 106-6876 Pin Diameter after plating ... 79.850 0.040 mm (3.1437 0.0016 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (3) 137-2919 Sleeve Bearing Quantity ... 2 Outside diameter ... 95.180 0.013 mm (3.7472 0.0005 inch) Inside diameter ... 80.2925 0.0425 mm (3.1611 0.0017 inch) Install the bearing in the bearing bore. ... 6.0 0.8 mm (0.24 0.03 inch) (4) Lubricate the sealing lip slightly with the lubricant that is being sealed. The seal must not extend past the face of the boss. (5) Two 106-6878 Pins Diameter after plating ... 69.850 0.040 mm (2.7500 0.0016 inch) Minimum thickness for plating ... 0.013 mm (0.0005 inch) (6) Position the four nuts past the end of the four bolts. ... 0.5 mm (0.02 inch) (7) Torque for four nuts (7) against four nuts (6) ... 240 40 N m (177 30 lb ft) (8) 143-3834 Sleeve Bearing Quantity ... 2 Outside diameter ... 85.160 0.013 mm (3.3527 0.0005 inch) Inside diameter ... 70.230 + 0.074 - 0.000 mm (2.7650 + 0.0029 - 0.0000 inch) Install the bearing in the bearing bore. ... 7.5 0.8 mm (0.30 0.03 inch)