BUSHING 2136719 - Caterpillar

- Active - This pertains to the status of a fault or to the status of a service code. When the fault is active, the fault is currently present.Alert Indicator - An alert indicator is a red indicator lamp. The alert indicator is located on the top portion of the monitoring system display. The alert indicator notifies the operator of an abnormal condition. When only the alert indicator is illuminated, a Warning Category 1 is indicated.+Battery - This pertains to any of the harness wiring which is part of the circuit that connects to the + battery post.Cat data link - The Cat data link is an electrical connection for communication with onboard devices that use the Data Link (ECM, CMS, VIMS, electronic power train, electronic dashboards and service tools such as Caterillar Electronic Technician). The Cat data link is also the medium that is used for programming with Caterpillar service tools and for troubleshooting with Caterpillar service tools.Clear - This refers to removing diagnostic information from the memory of the ECM. Before clearing a diagnostic code, the diagnostic code must be on hold and the diagnostic code must be inactive.Component Identifier (CID) - A CID is a code that is used to identify a particular component.Connector Contact - A connector contact is the component that actually makes the electrical connection between the harness connector and another connector plug.Detected Fault - This is a fault that has been found by the ECM. The fault is recorded and diagnostic information is available in the service mode.Diagnostic - This pertains to the monitoring of information that is abnormal and/or the recording of information that is abnormal. Diagnostic information can be accessed from the service, the status, the tattletale or the numeric readout mode. Diagnostic Code - This is a code which describes a problem in a system.Digital Sensors - Digital sensors produce PWM signal (duty cycle signal). These sensors are powered from a power supply of 8 to 28 DCV.Digital Signal - This signal is a PWM signal (duty cycle) that has a variable width and a constant amplitude. Also see "Pulse Width Modulation (PWM)".Display - Display refers to the gauges, the indicators, or the readouts within the Caterpillar Monitoring System display area.Fault - A fault is a failure of a component in an electronic system. An FMI and a CID identify the type of fault.Flash Programming - This is a means of reprogramming the personality module in the ECM without needing to replace the module.Failure Mode Identifier (FMI) - An FMI is a diagnostic code that identifies the type of failure that has occurred. The FMI consists of two digit code which is preceded by a decimal point ".". This code is shown on the display area when the main display module is in service mode.Fuse - A fuse is a replaceable safety device for an electrical circuit.Ground - A ground is any part of a wiring circuit that accidentally touches a part of the machine frame.Grounded Circuit -