BUSHING 2285621 - Caterpillar

Probable Causes
The ignition shutdown switch is in the OFF position.
Electrical connectors or power supply
Fuel supply or carburetor
No signal from the speed/timing sensor
EIS control module
Ignition systemRecommended Repairs
Ignition Shutdown Switch
Refer to Troubleshooting, "Ignition Shutdown Circuit".Electrical Connectors or Power Supply
There may be an intermittent interruption of power. Check the wiring harnesses and the connectors. Inspect the connectors in the terminal box. Inspect the power supply connections and the ground.Inspect the wiring from the power supply to the EIS control module. Check the power and ground connections. Refer to Troubleshooting, "Electrical Power Supply".Fuel Supply
Make sure that fuel is supplied at a sufficient pressure that is stable. Make sure that the size of the fuel line is sufficient. Inspect the fuel system for leaks.The following conditions can cause the engine to malfunction:
Low fuel pressure
High fuel pressure
Poor fuel qualityMake sure that the fuel pressure is correct. When possible, interview the operator in order to determine if fuel quality is in question. Try to determine if the source of the fuel was changed.Inspect the fuel system components: fuel filter, gas pressure regulator, gas shutoff valve and fuel metering valve. Verify that the system's components are operating correctly.Replace the fuel filter, if necessary.No Signal from the Engine Speed/Timing Sensor
Make sure that the speed/timing sensor is installed correctly. Refer to Troubleshooting, "Engine Speed/Timing Sensor".Make sure that the timing wheel is correctly installed.EIS Control Module
Verify that the control module is working properly. Refer to Troubleshooting, "Control Module Self Test".Electrical Connections to the Ignition System
Inspect the ignition transformers for the following conditions:
Loose connections
Moisture
Short circuits
Open circuitsInspect the primary wiring and the secondary electrical connections.Make sure that the correct transformers and spark plugs are installed. Inspect the extenders for signs or pin holes and arcing.Maintain the spark plug according to Operation and Maintenance Manual, "Ignition System Spark Plugs - Check/Adjust/Replace".Make sure that the ignition timing is correct.