2402917 BUSHING Caterpillar parts
320C FM, 320D, M325C MH, M325D L MH, M325D MH, M330D
Rating:
Alternative (cross code) number:
CA2402917
240-2917
2402917
CA2402917
240-2917
2402917
Weight: 3 pounds 1 kg.
Information:
ID
90.25
mm
OD
106.2
mm
WIDTH
90
mm
EXCAVATOR, WHEELED EXCAVATOR,
You can buy:
US$59.99
28 May 2025
FridayParts
Compare Prices: .
As an associate, we earn commssions on qualifying purchases through the links below
Number on catalog scheme:
8A
For full view, you need register
Compatible equipment models: 2402917:
Information:
Illustration 1 g00564773
Schematic of the rocker switch (ARC)This switch has two inputs to the brake/cooling ECM. The two inputs are normally open and normally closed. During normal operation, one of the inputs is open. The other input is grounded. When a circuit is measured with a voltmeter, an open circuit will measure approximately 5 DCV and a closed circuit will measure approximately 0 DCV. An FMI 04 diagnostic code is recorded when the status of both the inputs are grounded.The possible causes of this diagnostic code are listed below:
The "N/O" signal circuit (wire K986-PK) is shorted to ground.
The "N/C" signal circuit (wire K985-BR) is shorted to ground.
The parking brake switch has failed.
The ECM has failed. This is unlikely. Test Step 1. CHECK THE SWITCH
Turn the key start switch to the ON position.
The diagnostic code is active.
Remove the wire from contact 2 (wire J767-GY) at the switch.
Toggle the switch and note the status of the diagnostic code.Expected Result:The diagnostic code is no longer active in either position.Results:
OK - The diagnostic code is no longer active in either position.Repair: The parking brake switch has failed. Replace the switch. Verify that the new switch corrects the diagnostic code. Stop.
NOT OK - The diagnostic code is active in at least one of the positions. Proceed to Test Step 2.Test Step 2. CHECK THE SIGNAL CIRCUITS FOR A SHORT TO GROUND
Turn the key start switch to the OFF position.
Disconnect the machine harness connector J1 from the brake/cooling ECM.
Measure the resistance between contact J1-54 (wire K986-PK) and frame ground.
Measure the resistance between contact J1-55 (wire K985-BR) and frame ground.Expected Result:The resistances should be greater than 5000 ohms.Results:
OK - The resistances are greater than 5000 ohms.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the diagnostic code is still present, replace the ECM. Refer to Testing And Adjusting, "Electronic Control Module (ECM) - Replace". Stop.
NOT OK - The resistance is less than 5000 ohms on one of the readings.Repair: The circuit with the low resistance is shorted in the machine harness. Repair the machine harness or replace the machine harness. Stop.
Caterpillar parts catalog:
Parts bushing Caterpillar catalog:
1390, 2590, 320B, 320C, 322B, 322B L, 322B LN, 322C, 322C FM, 323D L, 324D, 324D L, 324D LN, 324E, 324E L, 324E LN, 325, 325 L, 325 LN, 325B, 325B L, 325C, 325C FM, 325C L, 325D, 325D FM, 325D FM LL, ...
325 L, 325B L, 325C, 325C FM, 325D FM, 325D FM LL, 325D MH, 330, 330 FM L, 330 L, 330B, 330B L, 330C FM, 330D FM, 350, 350 L, 375, 568 FM LL, M325B, M330D
330B L, 330C FM, 330D FM, 345B II, 345B L, 350, 350 L, 568 FM LL, M330D
322B L, 322C, 322C FM, 324D FM, 324D FM LL, 325B L, 328D LCR, 330, 330 L, 330B, 330B L, 330C FM, 330D FM, 345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, ...
324D, 325B L, 325C, 325C FM, 325D FM, 325D FM LL, 329D LN, 330, 330 L, 330B, 330B L, 330C, 330C FM, 330C L, 330C MH, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336...
320C, 324D, 324D FM LL, 324D L, 324D LN, 324E, 324E L, 324E LN, 325B L, 325C, 325D, 325D L, 325D MH, 326D L, 328D LCR, 329D, 329D L, 329D LN, 329E, 329E L, 329E LN, 330C, 330D, 330D FM, 330D L, 330D L...
24H, 24M, 325B L, 325C FM, 325D FM, 325D FM LL, 330B L, 330C FM, 330D FM, 345B, 345B II, 345B II MH, 345B L, 345C, 345C L, 345D, 345D L, 345D L VG, 349D, 349D L, 349E, 349E L, 349E L VG, 349F L, 350, ...
330C, 330C L, 330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L, 345B II, 345B L, 345C, 345C L, 345C MH, 3...
320B, 320B FM LL, 320C, 320C FM, 320D, 320E, 320E L, 320E RR, 321B, 321C, 321D LCR, 322, 322B, 322C, 324D, 324D L, 324E, 324E L, 324E LN, 325B, 325C, 325C L, 326D L, 328D LCR, 330C L, 375
320B, 320D, 322B, 325B, 375
320B, 320B FM LL, 320C FM, 320D, 322B, 325B, 375
320B, 320C, 320C FM, 320C L, 321B, 321C
1948330
BUSHING
320C FM, 322C FM, 325C FM, 330C FM
320C FM, 322C FM, 325C FM, 330C FM
321C, 322C, 325C, 330C, 330C FM, 330C L, 385B
322C, 322C FM
322C, 325C, 330C, 330C FM, 330C L, 385B, 385C L
322C, 325C, 330C, 330C FM, 330C L, 385B, 385C L
322C, 325C
2251005
BUSHING
554, 564, 574B
554, 564, 574B
2129962
BUSHING AS
HH44 DE, HH45, HH500, HH55, HH65, HH75
HH44 DE, HH45, HH500, HH55, HH65, HH75
2102657
BUSHING
320C, 320D FM, HF181, HF221
320C, 320D FM, HF181, HF221
2266332
BUSHING
320C, 320D FM, 543, HF181, HF201, HF201B, HF202, HF221, HF222, SC-57, SH-56B, SS-56
320C, 320D FM, 543, HF181, HF201, HF201B, HF202, HF221, HF222, SC-57, SH-56B, SS-56
2021096
BUSHING
M322C, M322D, M322D MH
M322C, M322D, M322D MH
M322C, M322D, M322D MH