BUSHING 2406411 - Caterpillar

Illustration 1 g00590119
Tilt the work tool to the full BACK position. Lower the lift arms to the LOWEST position. Stop the engine.
The adjusting rod should be set according to the following chart.
Table 1
Model     Dimension (A)    
928F, 928G     284 mm (11.2 inch)    
938F, 938G    
284 mm (11.2 inch)    
950F- 980F    
245 mm (9.6 inch)    
950G, 962G, 980G    
215 mm (8.5 inch)    
966G, 972G    
170 mm (6.7 inch)    
988 through 994    
149 mm (5.9 inch)    Note: The lift linkage position sensor is ONLY adjustable on the machines that are listed in Table 1. If the machine that is being serviced is not listed in the table, the lift linkage position sensor is NOT adjustable.
Connect the rod assembly to the bail (1) and the lever (2) for the position sensor.
Make sure that the lever (2) can rotate freely on the shaft (3) of the position sensor.
Place the payload control system (PCS) in the Weigh Mode. Press the "SERV" key.
Press the "NEXT FUNCTN" key for one time. The display will show the current position of the lift arm. The measured units are related to the angle of the lift arm.Note: Do not extend the position sensor past the maximum limits. Damage to the position sensor may occur.
Rotate the shaft (3) clockwise until a resistance is felt. Record the maximum position that is shown on the display.
Rotate the shaft (3) in order to achieve a reading between 6500 and 25000. Tighten the bolt that holds the lever (2) onto the shaft (3) .
Start the engine. Raise the lift arms slowly while you observe the reading on the display. If the reading reaches the value in Step 7 minus 1500, return the lift arm to the fully lowered position. Shorten the length of the adjusting rod in order to obtain a lower reading.
Raise the lift arm again while you observe the reading on the display. The reading should be between 44500 and 61600. If the reading is over 61600, repeat Step 8 through Step 10. Use a lower reading when you repeat these steps.