BUSHING 2409955 - Caterpillar

Table 2
Required Tools    
Part Number     Description     Quantity    
JEBD3003     Caterpillar Electronic Technician (ET)     1    
171-4400     Communication Adapter Tool     1    The software program that will be used for this test procedure is the Caterpillar Electronic Technician (ET). The Caterpillar Electronic Technician is a software program that can be used on an IBM-compatible personal computer. Refer to the Service Manual, JEBD3003 for the requirements in order to install ET.
Open the software program (ET). Select the transmission ECM for the machine that is being calibrated.
Illustration 4 g01432108
Select the "Service" menu in order to begin the calibration procedure. Then select "Calibrations". A second menu will be displayed. Select "Transmission Fill Calibration" from the second menu.
Illustration 5 g01432109
The next screen is the initial calibration screen. Once "Transmission Fill Calibration" has been selected, the screen displays the instructions for calibration. The top display area displays status parameters that are monitored during the calibration. The middle display area displays information about the status of the calibration. The display area on the bottom will display the conditions for the setup and the display area on the bottom will also display the instructions for the calibration.
The display area will show the following conditions for the setup:
Warm the transmission oil to a minimum of 60 °C (140 °F).
Place the transmission direction and speed control lever in the NEUTRAL position.
Engage the parking brake.
Operate the engine at high idle.
Perform the following procedures in order to satisfy the condition for the setup.
Illustration 6 g01442316
Illustration 7 g01442318
Perform the following procedure in order to warm the transmission oil:
Engage the parking brake.
Lower the implement.
Place the autoshift switch (8) in the MANUAL position.
Place the transmission direction and speed control lever (7) in the third gear position.
Shift the transmission direction and speed control lever in the FORWARD position.
Operate the engine at high idle. Use the throttle lock (if equipped) in order to set the engine high idle speed. Monitor the gauge for the torque converter oil temperature that is on the dash panel. Reduce the engine speed and shift the transmission into the NEUTRAL position when the gauge enters the high temperature area. Shift the transmission back into gear once the temperature returns to normal.
Use the ET calibration screen in order to monitor the transmission oil temperature.
Maintain the transmission oil temperature that is displayed by ET between 3 minutes and 5 minutes in order to properly heat up the transmission.
Ensure that the transmission direction control lever is in NEUTRAL.
Ensure that the parking brake is engaged.
Use the throttle lock (if equipped) in order to set the engine at high idle.
Illustration 8 g00952529
Note: When the calibration has been performed on all of the clutches a dialog box will display the results for each clutch. There are only two possible results: "Success" and "At a limit".
Press the "Next>" button in order to start the calibration. If the conditions for the setup are not correct, the condition that is not correct will be display in the middle display area. The calibration will not