BUSHING 2631439 - Caterpillar

Removal Procedure
Start By:
Remove the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01027007
Remove bolts (1).
Remove rear seal carrier (2). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-8440 Component Cleaner
B 169-5464 Quick Cure Primer
C 1U-8846 Gasket Sealant
D 9S-3263 Thread Lock Compound
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 2 g01027007
Clean the joint face of rear seal carrier (2) and the cylinder block with Tooling (A).
Apply Tooling (B) to the joint face of rear seal carrier (2). Allow the primer to air dry for three to five minutes. Note: Tooling (C) is used on the joint face of rear seal carrier (2). Do not allow the sealant to get into the oil passage in the mounting face of the cylinder block.
Apply Tooling (C) to the joint face of rear seal carrier (2). Spread the sealant uniformly. Rear seal carrier (2) must be installed within ten minutes of application of the sealant.
Position rear seal carrier (2) on the dowels in the rear of the cylinder block.
Apply Tooling (D) on the threads of bolts (1). Install bolts (1) that hold rear seal carrier (2) to the cylinder block. End By:
Install the flywheel housing. Refer to Disassembly and Assembly, "Flywheel Housing - Remove and Install".