BUSHING (MASTER) 2M9614 - Caterpillar

Probable Causes
Diagnostic codes
Electrical connectors
ECM connection
Fuel supply
Intake manifold pressureRecommended Actions
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking the engine again.
Diagnostic Codes
Use one of the following methods to check for active diagnostic codes:
The electronic service tool
The display on the control panelElectronic Service Tool
Connect the electronic service tool to the diagnostic connector.
Check for active diagnostic codes on the electronic service tool.
Investigate any active codes before continuing with this procedure. Refer to Troubleshooting, "Troubleshooting with a Diagnostic Code".Display on the Control PanelNote: The following procedure is only applicable if the application is equipped with a display on the control panel.
Check the display on the control panel for active diagnostic codes.
Troubleshoot any active codes before continuing with this procedure. Refer to Troubleshooting, "Troubleshooting with a Diagnostic Code".Electrical Connectors
Refer to Troubleshooting, "Electrical Connectors - Inspect".
Repair the electrical connectors or replace the electrical connectors.
Ensure that all the connector seals are in place and that the connectors have been correctly installed.
Ensure that the repairs have eliminated the fault. If the fault has not been eliminated proceed to "ECM Connection".ECM Connection
Check that the P2/J2 connector is correctly fitted.
Check that the P1/J1 connector is correctly fitted.
If a fault is suspected with the ECM power and ground connections, refer to Troubleshooting, "Ignition Keyswitch Circuit and Battery Supply Circuit - Test".
Verify that the ECM connections for the power and ground connections at the fuel pump are correctly connected.
Repair any faults and ensure that the faults have been eliminated.
If the repairs do not eliminate the faults, proceed to "Fuel Supply".Fuel Supply
Visually check the fuel tank for fuel. The fuel gauge may be faulty.
Ensure that the fuel supply valve (if equipped) is in the full OPEN position.
If the temperature is below 0 °C (32 °F), check for solidified fuel (wax).
Check the primary filter/water separator for water in the fuel.
Check for fuel supply lines that are restricted.
Check that the Electric Fuel Lift Pump (EFLP) is operating. If the EFLP is suspect, refer to Troubleshooting, "Fuel Pump Relay Circuit - Test".
Check that the low-pressure fuel lines are tight and secured properly.
Check the fuel filters.
Check the diesel fuel for contamination. Refer to Systems Operation, Testing, and Adjusting, "Fuel Quality - Test".
Check for air in the fuel system. Refer to Systems Operation, Testing, and Adjusting, "Air in Fuel - Test".
Ensure that the fuel system has been primed. Refer to Systems Operation, Testing, and Adjusting, "Fuel System - Prime".
Check the fuel pressure. Start the engine and then use the electronic service tool to check that the pressure in the fuel rail is more than 18000 kPa (2610 psi).
If the fault has not been eliminated, perform the following procedure:Note: Before performing the following fuel system tests, the engine must be stopped for a minimum of 30 minutes.Note: When performing the following fuel system tests, the Electric Fuel Lift Pump (EFLP) will only operate for 2 minutes unless the engine is running. If necessary, cycle the keyswitch in order to reactivate the pump.
Illustration 1 g02337318
(1) Secondary