BUSHING 3241163 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    Start By:
Remove the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Remove".
Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01910054
Illustration 2 g01910077
Remove bolts (1) and retainer (2). Remove gear assembly (3). Repeat for gear assembly (4) .
Attach Tooling (A) and a suitable lifting device to flywheel housing (6). The weight of flywheel housing (6) is approximately 113 kg (250 lb).
Remove bolts (5). Use Tooling (A) and the suitable lifting device in order to remove flywheel housing (6) .Installation Procedure
Table 2
Required Tools    
Tool    Part Number    Part Description    Qty    
A     138-7575     Link Bracket     2    
B     1U-8846     Gasket Sealant     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g01910077
Illustration 4 g01910054
Apply Tooling (B) to the entire mounting surface of flywheel housing (6). Flywheel housing (6) must be installed within 10 minutes of applying Tooling (B) .
Attach Tooling (A) and a suitable lifting device to flywheel housing (6). The weight of flywheel housing (6) is approximately 113 kg (250 lb). Use Tooling (A) and the suitable lifting device in order to position flywheel housing (6) to the engine. Install bolts (5) .
Install gear assembly (3). Install retainer (2) and bolts (1). Repeat for gear assembly (4) .End By:
Install the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".
Install the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Install".