BUSHING 3812786 - Caterpillar

Removal Procedure for the PTO (If Equipped)
Start By:
Remove the V-belts for the PTO. Each application may be different. Refer to the OEM of the driven equipment for the removal procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00767312
Remove allen head screws (3) from taper lock (2). Remove taper lock (2) from pulley (1). Remove the pulley.
Illustration 2 g00767851
Remove bolts (5) that hold PTO shaft (4) onto the vibration damper. Remove the PTO shaft.Removal Procedure for the Crankshaft Pulley
Start By:
Remove the V-Belts. Refer to Disassembly and Assembly, "V-Belts - Remove and Install".
Illustration 3 g00797294
Illustration 4 g00797295
Remove two bolts (1) that secure engine turning device (2) to crankshaft pulley (3) .
Illustration 5 g00798454
Remove three bolts (4) that secure the thrust block (5) to the crankshaft. Remove the thrust block.
Remove the crankshaft pulley (3) from the engine.Installation Procedure
Illustration 6 g00797295
Illustration 7 g00798454
Install crankshaft pulley (3) onto the engine.
Lubricate bolts (4) with clean engine oil.
Install thrust block (5) and three bolts (4). Tighten the bolts gradually and tighten the bolts evenly to a torque of 115 N m (85 lb ft).
Illustration 8 g00797294
Install the engine turning device (2) with two bolts (1) .
Tighten the bolts (1) to a torque of 75 N m (55 lb ft).End By: Install the V-Belts. Refer to Disassembly and Assembly, "V-Belts - Remove and Install".Installation Procedure for the PTO (If Equipped)
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 9 g00767851
Install PTO shaft (4) onto the front face of the vibration damper.
Tighten bolts (5) for the PTO shaft and the vibration damper to a torque of 130 N m (96 lb ft).
Loosen bolts (5) for the PTO shaft and the vibration damper.
Again tighten bolts (5) to a torque of 130 N m (96 lb ft).
Illustration 10 g00767312
Clean the mounting face of pulley (1). Clean taper lock (2) .
Install taper lock (2) into pulley (1).
Install pulley (1) for the PTO onto PTO shaft (4). Align the key (if equipped) and fully seat the key.
Lightly oil allen head screws (3) before installation. Install allen head screws (3) .
Tighten allen head screws (3) in an star pattern.
Ensure that taper lock (2) is seated square. Hammer around the large end of the taper lock by using a drift pin and a hammer.
Finally tighten allen head screws (3) to a torque of 30 N m (22 lb ft).End By: Install the V-belts for the PTO. Each application may be different. Refer to the OEM of the driven equipment for the installation procedure.