BUSHING 3F6997 - Caterpillar

Table 1
Display     Description    
OL-EL     Engine Speed too low    
OL-EH     Engine Speed too high    
OL-XN     Neutral not selected    
OL-TL     Oil Temperature too low    
OL-TH     Oil Temperature too high    
OL-VS     Vehicle speed not zero    Once all conditions are met, the range display will show 24 and will count down to 0 during the two-minute counter period. At the end of two-minute countdown, one of the following will be displayed using the range display, two characters at a time.
Table 2
Display     Description    
OL-LO-XX     Oil Level is low by XX quarts    
OL-HI-XX     Oil Level is high by XX quarts    
OL-OK     Oil Level is full    The Oil Level Message continues to display until the operator exits the mode by pressing a range button or the "Up/Down" arrows simultaneously. The transmission will not take action at the end of the oil level check. This check is for the operator and the operator must take appropriate action for an indicated oil level that is either high or low.Note: Periodically the manual oil level dip stick should be compared to the electronic oil level display to insure both methods provide comparable results.Dual Shift Selector PadsSome vehicle configurations require that the transmission is temporarily controlled from a remote location. Up to two Shift Selector Pads may be used on one vehicle. A vehicle mounted Shifter Selector switch is used to tell the transmission which shifter is to be in control of shifting. To change between Shift Selector Pads, both shift selector pads must be in Neutral and the vehicle must be stationary. The Shifter Selector switch may then be used to designate which shift selector pad is to be used. When the primary shifter is selected, the maximum gear available will be displayed on the left side of the display. When the secondary shifter is selected, the maximum forward gear displayed on the left side of the display will be 1 (one). The transmission will not automatically shift into a higher gear except for engine overspeed protection. The operator may use the arrow buttons to increase the highest desired forward gear when using the secondary shifter.Display IlluminationThe illumination level of the display is normally tied to the dash illumination level control. An optional vehicle mounted switch, if so equipped, may be used to disable the display. Shift Selector Mounting Considerations
Push Button Shift Selector Mounting Considerations
Illustration 8 g02355238
Reference assembly 304-9080 Transmission Control Gp View of Shift PadThe illustration shows outer dimensions in inches for the pad. (A) 38.4 mm (1.51 inch) (B) 172.2 mm (6.78 inch) (C) 81.0 mm (3.19 inch)Table 3 shows metric and inch equivalents for the push button shift selector panel cutout.
Table 3
Mounting Measurements - Keypad Shifter    
Width    
77.7 to 78.7 mm (3.06 to 3.10 inch)    
Length    
167.4 to 168.4 mm (6.60 to 6.63 inch)    
Depth     Maximum
110 mm (4.33 inch) deep (includes rear connector and wire clearance)