BUSHING 4368719 - Caterpillar

Illustration 1 g00493263
Components of the VIMS Display
(1) Gauge cluster
(2) Speedometer/tachometer module
(3) Message center
(4) Alert indicator
(5) Data logging indicator
(6) Gauges
(7) Tachometer
(8) Ground speed readout
(9) Gear readout
(10) Message area
(11) Universal gauge
(12) Gauge warning area The VIMS will alert the operator if an abnormal condition occurs with the machine. The information can be helpful in troubleshooting the problems of the machine. The information can give an idea of the problems which may need repair.Most of the system events for the VIMS are delayed by eight seconds from the beginning of the event until the event is displayed. Any system event that is shown in the event list will include the eight second duration of the event. System events that originate in other Electronic Control Modules are delayed in the software of that ECM. System events that pertain to the VIMS are not included. The VIMS will immediately show an event when the event is shown in the original ECM.ACTIVE maintenance events are shown in message area (10). A maintenance event is specified by showing that a parameter has an ERROR. Also, instructions are given to the operator. An example of an instruction would be “CALL SHOP”. Each system event that is ACTIVE will scroll in the message area in three second intervals. The following illustration is an example of an error in the circuit for the latching pressure sensor of the transmission.
Illustration 2 g00581855Press the F1 key in order to toggle the display. The display will show the diagnostic codes for the system events. The following illustration is an example.
Illustration 3 g00581856Press the F1 key in the gauge mode in order to view the fault. Press the F1 key again in order to view the FMI code. The following statement is an example.“Short to ground”.Use the procedure with the same diagnostic code in order to troubleshoot a maintenance event for the VIMS.List of Data Events for the VIMS
Table 1
Parameter Component Warning Message Level of the Event
F IMPL PMP FLT Filter Bypass Switch of the Front Center Implement Pump "F IMPL PMP FLT PLGD"
"CALL SHOP" 2
F PMP DRV FLT Bypass Switch of the Front Pump Drive "F IMPL PMP FLT PLGD"
"CALL SHOP" 2
F PMP DRV FLT Bypass Switch of the Front Pump Drive "F IMPL PMP FLT PLGD"
"SHUTDN SAFELY" 3
F PMP DRV TEMP Temperature Sensor of the Front Pump Drive "F PMP DRV TEMP HI"
"CALL SHOP" 2
IMPL COOL FLT Bypass Switch of the Cooling Filter for the Implement "IMPL COOL FLT PLGD"
"CALL SHOP" 2
IMPL COOL FLT Bypass Switch of the Cooling Filter for the Implement "IMPL COOL FLT PLGD"
"SHUTDN SAFELY" 3
IMPL OIL LVL Oil Level Switch of the Implement Tank "IMPL OIL LVL LO"
"ADD OIL IMMEDIATELY" 2
IMPL OIL LVL Oil Level Switch of the Implement Tank "IMPL OIL LVL LO"
"FILL BEFORE STARTUP" 2
IMPL OIL TEMP Oil Temperature Sensor of the Implement "IMPL OIL TEMP HI"
"IDLE@1700 IN NTRL" 2
IMPL OIL TEMP Oil Temperature Sensor of the Implement "IMPL OIL TEMP HI"
"SHUTDN SAFELY" 3
IMPL PILOT FLTR Implement Pilot Filter Bypass Switch "IMPL PILOT FLTR PLGD"
"CALL SHOP"