BUSHING 4646782 - Caterpillar

Installation Procedure
Note: Cleanliness is an important factor. Before assembly, thoroughly clean all parts in cleaning fluid. Allow the parts to air dry. Do not use wiping cloths or rags to dry parts. Lint may be deposited on the parts which may cause trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement. Dirt and other contaminants can damage the precision component. Perform assembly procedures on a clean work surface. Keep components covered and protected at all times.Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01330794
Connect tube assemblies (6) .
Illustration 2 g01330780
Connect harness assemblies (5) .
Illustration 3 g01330753
Install tube assemblies (4). Connect hose assemblies (3) .
Illustration 4 g01330748
Install plate assembly (2). Use two people to install cover assembly (1). The weight of cover assembly (1) is approximately 24 kg (52 lb).End By: Install the track drive motor in the right side of the machine. Refer to Disassembly and Assembly, "Track Drive Motor - Install".