BUSHING-TRACK 5678596 - Caterpillar

Illustration 1 g03383268The following service programs and functions are available from the controller:
The controller informs the monitoring system about the condition of the machine. Some examples are: hydraulic oil temperature, engine coolant temperature, and fuel level.
The controller informs the monitoring system about any existing and/or past failures of the electronic control system.
Various settings of the controller are performed.
Adjustment and testing of the electronic control system are performed.
Illustration 2 g03587478
(1) Keypad guidance area
(2) Back key
(3) "OK" key
(4) Left key
(5) Up key
(6) Down key
(7) Right key Procedure to Enter the Service Mode
The keys of the keypad and Soft Switch can be used to enter the service mode. Press the appropriate key until the desired mode is displayed on the message center. Use the following steps to enter the service mode.
Illustration 3 g03578236
From the Main Menu, the screen in Illustration 3 will be displayed. Press the Right key (7) or the Left key (4) until "Service" is highlighted.
After "Service" is highlighted, press the "OK" key (3).
Illustration 4 g03578257
After the "OK" key (3) is pressed, the above screen will be displayed. The direction keys are used to input the password. The password that allows access to all service menus is "9992". For more information on password entry, refer to the Systems Operation, "Password Entry" section of this manual.
When the correct password has been entered, the monitor indicates that the service mode has been entered. The following options are available and will be discussed in detail in this manual:
ECM Summary
Diagnostic
Status
Configurations
Tool Programming
Override Parameters
Calibrations
Device Test
Win FlashExiting the Service Mode
Exiting the service mode is done by turning the key start switch to the OFF position. The service mode will be terminated ten seconds after the start switch is turned to the OFF position. If you want to exit the service mode but do not want to turn off the machine, press the Home key during the process of a function. The monitor will require one to two seconds to return to the default screen.