BUSHING 7B5458 - Caterpillar

Table 1
Required Tools
Part Number Description Required Amount
198-4240 Digital Pressure Indicator 1
5P-1404 O-Ring Adapter 2
6V-3965 Fitting As 2
8S-2263 Spring Tester 1
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
When a slack adjuster strokes correctly, there is always a small amount of pressure on the piston in the "Service Brakes" after the brakes are released.Use the following procedure to check for a failure in a slack adjuster.Rear Brakes
Illustration 1 g00645646
(1) Pressure tap
Remove the dust cap from pressure tap (1) of the "Rear Brake Slack Adjuster".
Illustration 2 g00645569
Rear brake housing
(P) Purge Valve for Parking Brakes
(S) Purge Valve for Service BrakesNote: Identification letters are embossed on the purge valves at the top of the brake housing. The "Purge Valve for the Parking Brake" is labeled with a "P". The "Purge Valve for the Service Brake" is labeled with an "S".
Remove purge valve "S" on both sides of the machine. Use the 5P-1404 O-Ring Adapter to install a 6V-3965 Fitting As.
Start the machine.Note: Make sure that the system air pressure is at the maximum pressure.
Depress the "Service Brake Pedal" to engage the brake.
Use 198-4240 Digital Pressure Indicator to check the pressure at test port (1) and each of the 6V-3965 Fitting As on the rear brakes. The pressure should be equal at each location.
Release the brakes.
There should be residual pressure at each 6V-3965 Fitting As when the "Service Brakes" are released. The oil pressure should be 127 kPa (18 psi).Note: Low residual pressure indicates a failed slack adjuster. High residual pressure may indicate a failed slack adjuster or warped brake discs. Rotate the wheel and check for pressure fluctuations to determine if the brake discs are warped. The brake discs are probably warped if the pressure fluctuates. If the brake discs are warped, the brake discs should be replaced.
If a problem is indicated, remove the slack adjuster. Refer to the procedure in "Check of Small Piston Movement".Check of Small Piston Movement
Illustration 3 g00336318
Check of small piston movement
Remove the piston from the housing for the slack adjuster.
Install a 6.35 mm (0.250 inch) diameter by 31.8 mm (1.25 inch) long rod into the hole of the piston, as shown.
Use an 8S-2263 Spring Tester to check the movement of the small piston inside the piston.
Put the piston in the tester. Apply force on the rod, as shown.
Apply a force of 220 N (50 lb) on the rod. If the small piston does not move, replace the piston with a new piston.
If the slack adjuster is not damaged, check for damaged oil seals and for brake oil leakage in the brake piston seals.
Personal injury or death can result