BUSHING 9M3515 - Caterpillar

Use this procedure to troubleshoot the electrical system if a problem is suspected with an engine temperature sensor. Also, use this procedure if any one of the diagnostic codes in Table 1 is active or easily repeated.
Table 1
Diagnostic Codes Table    
Code and Description    Conditions which Generate this Code    System Response    
105-3 Engine Intake Manifold #1 Temperature : Voltage Above Normal     The Electronic Control Module (ECM) detects a signal voltage that is more than 4.95 VDC for ten seconds.     The code is logged.
The amber warning lamp is illuminated.
The service tool displays "Error Indicator" on the status screen for this parameter.    
105-4 Engine Intake Manifold #1 Temperature : Voltage Below Normal     The ECM detects a signal voltage that is less than 0.2 VDC for eight seconds.    
110-3 Engine Coolant Temperature : Voltage Above Normal     The ECM detects a signal voltage that is more than 4.95 VDC for ten seconds.     The code is logged.
The amber warning lamp is illuminated.
The service tool displays "Error Indicator" on the status screen for this parameter.    
110-4 Engine Coolant Temperature : Voltage Below Normal     The ECM detects a signal voltage that is less than 0.2 VDC for eight seconds.    
175-3 Engine Oil Temperature 1 : Voltage Above Normal     The ECM detects a signal voltage that is more than 4.95 VDC for ten seconds.     The code is logged.
The amber warning lamp is illuminated.
The service tool displays "Error Indicator" on the status screen for this parameter.    
175-4 Engine Oil Temperature 1 : Voltage Below Normal     The ECM detects a signal voltage that is less than 0.2 VDC for eight seconds.    
Illustration 1 g01961988
Schematic for the passive analog sensorSystem OperationUse this procedure to troubleshoot any suspect problems with the temperature sensors for the engine.The sensor signal for the passive sensor is routed from the ECM to terminal 1 of the sensor connector. The sensor return for the passive sensors is routed from the ECM to terminal 2 of the sensor connector.The most likely cause of a code is a problem with an electrical connector or wiring. The least likely cause of a code is the ECM.
Illustration 2 g01962016
Locations of the passive analog sensor (left side engine view) (1) Engine coolant temperature sensor (2) Intake manifold air temperature sensor (3) Engine oil temperature sensor
Illustration 3 g01962019
Locations of the connectors at the ECM (right front engine view) (4) J2/P2 ECM connectors
Illustration 4 g01962021
Terminal locations at the P2 ECM connector for the passive analog sensors (P2-36) Engine oil temperature (P2-39) Analog return (P2-42) Intake manifold air temperature (P2-43) Engine coolant temperature
Illustration 5 g01436505
Terminal locations at the connector for the passive analog sensor (Terminal 1) Sensor signal (Terminal 2) Analog sensor return
Table 2
Troubleshooting Test Steps    Values    Results    
1. Check for Active Diagnostic Codes and Check for Logged Diagnostic Codes
A. Connect Caterpillar Electronic Technician (ET) to the service tool connector. Refer to Troubleshooting, "Electronic Service Tools", if necessary.
B. Download the "Product Status Report" from the engine ECM