BUSHING 9R0321 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed. The user is responsible for the performance of all maintenance including the following procedures: all adjustments , the use of proper lubricants, fluids, filters and the installation of new components due to normal wear and aging . The performance of this product may be diminished if proper maintenance intervals and procedures are not followed. Components may experience accelerated wear if proper maintenance intervals and procedures are not followed.Note: Use whichever of the following that occurs first in order to determine the maintenance intervals: fuel consumption , service hours and calendar time . Before each consecutive interval is performed, all maintenance from the previous intervals must be performed.Products that operate in severe operating conditions may require more frequent maintenance.When Required
Battery - Recycle
Battery or Battery Cable - Disconnect
Coolant - Change
Coolant Extender (ELC) - Add
Engine Air Cleaner Element (Single Element) - Inspect/Clean/Replace
Engine Oil Level Gauge - Calibrate
Fuel System - Prime
Daily
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Water Separator - Check/Drain
Transmission Oil Level - Check
Walk-Around Inspection
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every Year
Coolant Sample (Level 2) - Obtain
Every 1500 L (400 US gal) of Fuel or 50 Service Hours
Zinc Rods - Inspect/Replace
First 7500 L (2000 US gal) of Fuel or 250 Service Hours
Engine Valve Lash - Check
Fuel Injection Timing - Check
Every 7500 L (2000 US gal) of Fuel or 250 Service Hours or 1 Year
Auxiliary Water Pump (Rubber Impeller) - Inspect
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Engine Crankcase Breather - Clean
Engine Oil Sample - Obtain
Engine Oil and Filter - Change
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Tank Water and Sediment - Drain
Hoses and Clamps - Inspect/Replace
Sea Water Strainer - Clean/Inspect
Water Pump - Inspect
Every 30 000 L (8000 US gal) of Fuel or 1000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Engine Protective Devices - Check
Engine Speed/Timing Sensor - Clean/Inspect
Turbocharger - Inspect
Every 60 000 L (16 000 US gal) of Fuel or 2000 Service Hours
Engine Mounts - Inspect
Engine Valve Lash - Check
Fuel Injection Timing - Check
Heat Exchanger - Inspect
Every 91 000 L (24 000 US gal) of Fuel or 3000 Service Hours or 2 Years
Coolant Temperature Regulator - Replace
Overhaul
Overhaul Considerations