BYPASS GP-EXHAUST 4W5947 - Caterpillar

the EMERGENCY STOP indicator flashes, the engine is shutdown and is not allowed to start. HIGH WATER TEMPERATURE (3) - A high water temperature shutdown set point is programmed into the GSC. Condition: the engine coolant temperature rises above the set point for high water temperature shutdown. Result: the HIGH WATER TEMPERATURE indicator flashes, the engine is shutdown and is not allowed to start. ENGINE OVERSPEED (4) - An engine overspeed set point is programmed into the GSC. Condition: the engine speed exceeds the engine overspeed set point. Result: The ENGINE OVERSPEED indicator flashes, the engine is shutdown and is not allowed to start. LOW COOLANT LEVEL (5) - Condition: the engine coolant level drops below the probe of the coolant loss sensor (optional). Result: the ENGINE COOLANT LEVEL indicator flashes, the engine is shutdown and is not allowed to start. An optional low coolant level sensor is required for this function. OVERCRANK (6) - A set point for total cycle crank time is programmed into the GSC. Condition: the engine does not start within the programmed set point. Result: the OVERCRANK indicator flashes and the engine is not allowed to start. The GSC can be programmed to override the shutdowns for: low oil pressure, high water temperature, and low coolant level faults. When these faults are overridden, the faults are treated as alarm conditions. The corresponding dedicated shutdown indicator is ON CONTINUOUSLY (instead of flashing) and the engine continues to run and start (instead of shutting down). The dedicated shutdown indicator that is ON CONTINUOUSLY means that the set point for the shutdown has been exceeded, but the GSC is programmed to override the shutdown condition and treat the fault as an alarm condition. As provided from the factory, the GSC treats low oil pressure, high water temperature and low coolant level as shutdowns. Refer to SENR5809, Electronic Modular Control Panel II, for programming procedures.Display
The upper display (1) and lower display (2) of the GSC provide information about the generator and engine.* The upper display (1) shows AC voltage, current, and frequency of one phase of the generator output. Each phase can be viewed one at a time by pushing phase select key (4). The upper display (1) is also used to show the various fault codes for system faults. For more information on fault codes, refer to SENR5809, Electronic Modular Control Panel II, for Fault Descriptions.* The lower display (2) shows: system battery voltage, engine hours, engine speed, engine oil pressure, and engine coolant temperature. The value for one of those conditions is displayed for two seconds, then the display scrolls to the value for the next condition. A small pointer identifies the engine condition that corresponds to the value that is showing. When the engine meter key (3) is pressed, the lower display stops scrolling and continuously shows one particular value. The pointer flashes above the condition whose value is showing. When the engine meter key is pressed