CAB AR-ENCLOSED ROPS 2152835 - Caterpillar

b) Install 5P5207 Stud (24) in 5P6222 Adapter (21). Slide 5P5212 Plate Assembly (22) and 5P5021 Cylinder (23) with the piston end away from the sprocket over stud (24) and against adapter (21). c) Put 6V4000 Head (25) on stud (24) so the flat side of the head is toward cylinder (23). d) Put 6V3125 Arms (27) in position in the head and the adapters and install 6V3126 Pins (26) and 6V3127 Locks (28). e) Put 5P5208 Nut (29) on stud (24) until it is 25.4 mm (1 in.) from head (25). Use tooling (E) to loosen the sprocket from the hub. 20. Fasten a hoist to the sprocket. Remove sprocket (30). The weight is 181 kg (400 lb.). Keep the Duo-Cone seals for the sprocket and final drive case together so they will not be mixed at assembly.21. Remove the Duo-Cone seals from the sprocket and the final drive case.Install Sprocket Assemblies
*These tools are part of 6v3180 Sprocket Tool Arrangement. The rubber seals and all of the surfaces that make contact with the rubber seal must be clean and dry with no damage to the contact surfaces. Put clean oil on the contact surfaces of the metal seals.
Typical Example1. Install the Duo-Cone seal in the final drive case with tooling (A). 2. Install Duo-Cone seal (1) in the sprocket with tooling (A).
Typical Example3. Fasten a hoist to sprocket (2) and put it in position on the final drive hub. Make sure the splines of the sprocket and the hub are in alignment. Push the sprocket on the hub as far as possible by hand.
Make sure the splines on the hub are clean and dry.
4. Put tooling (A) in position to install sprocket (2) as follows:a) Install 5P6222 Adapter (3). Turn the adapter until it is fully on the final drive hub. b) Install 5P5207 Stud (4) in adapter (3). c) Slide 5P6220 Sleeve (5) over adapter (3) and stud (4) until it makes contact with sprocket (2). d) Slide 5P5212 Plate (6) on stud (4) until it makes contact with sleeve (5). e) Put 5P5201 Cylinder (7) on stud (4). Slide the cylinder on the stud until the cylinder makes contact with plate (6). f) Put 5P5208 Nut (8) on stud (4) until the nut is 6.4 mm (0.25 in.) from cylinder (7). Connect 5P3100 Pump Group to cylinder (7) and use a force of 535 to 580 kN (60 to 65 ton) to push the sprocket on the final drive hub.
Be sure the piston of cylinder (7) is retracted before the cylinder is removed.
5. Remove tooling (C). Check the distance from the sprocket face to the spline shoulder on the final drive gear hub. The distance must be 12.7 1.52 mm (.500 .060 in.). 6. Install the lock and nut (9). Use tool (B) and tighten nut (9). 7. Heat bearing cone (10) to a maximum temperature of 135°C (275°F). Install bearing cone (10) on the hub and against the nut. 8. Lower the