CAB GP-NON-ROPS 3057178 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
(A) 138-7573 Link Bracket 1
Make sure that the threaded holes in the undercarriage frame assembly for mounting the swivel joint are clean and free of dirt and debris.
Apply a bead of 1U-8846 Liquid Gasket to the surface of the undercarriage frame assembly prior to installing the swivel joint.
Fasten Tool (A) and a hoist to the swivel joint. Place the swivel joint in the swivel joint's original position in the undercarriage frame assembly. Make sure that the identification mark on the bottom face of the swivel joint is facing toward the front of the machine.
Illustration 1 g00513219
This view is from the underside of the machine.
Apply 9S-3263 Thread Lock Compound on the threads of six bolts (9). Install six bolts (9) in the bottom of the swivel joint.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Remove the tape from the ports in the bottom of the swivel joint.
Install tee fitting (8) in the swivel group. Tighten the tee fitting to a torque of 40 5 N m (30 4 lb ft). Make sure that the tee fitting is oriented properly.
Remove the plugs from eight hose assemblies (7). Check the condition of the O-ring seals that are used in the ends of eight hose assemblies (7) prior to installation. If the O-ring seals are damaged, use new parts for replacement.
Connect eight hose assemblies (7) in the hose assembly's original location on the bottom of the swivel joint. Tighten the two hose assemblies that connect to tee fitting (8) to a torque of 40 5 N m (30 4 lb ft). Tighten the two hose assemblies that connect to the center tee fitting to a torque of 80 7 N m (60 5 lb ft). Tighten the four large diameter hose assemblies that connect to the bottom of the swivel group to a torque of 80 7 N m (60 5 lb ft).
Remove the hoist and Tool (A) from the top of the swivel joint. Reinstall the cover bolt in the top of the swivel joint.
Illustration 2 g00513210
Install setting plate (3). Install two bolts (2) and the washers that secure the setting plate.
Remove the plugs from the ends of seven hose assemblies (1). Check the condition of the O-ring seals that are used in the ends of seven hose assemblies (1) prior to installation. If the O-ring seals are damaged, use new parts for replacement.
Connect seven hose assemblies (1) in the hose assembly's original location on the swivel joint. Tighten the four large diameter hose assembly mounting bolts to a torque