CABINET GP-INVERTER 5588484 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Illustration 1 g01455591
Disconnect harness assembly (1) from fuel temperature sensor (2).
Remove fuel temperature sensor (2).
Remove the O-ring seal from fuel temperature sensor (2). Installation Procedure
Illustration 2 g01455591Note: Check the O-ring seal for wear or for damage. If necessary, replace the O-ring seal.
Install a new O-ring seal on fuel temperature sensor (2).
Install fuel temperature sensor (2). Tighten fuel temperature sensor (2) to a torque of 20 5 N m (15 4 lb ft).
Connect harness assembly (1) to fuel temperature sensor (2).
Purge the air from the fuel system.