CABLE A 0007569 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 189-0410 Shackle As 1
1U-9200 Lever Puller Hoist 1
B 138-7575 Link Bracket 2
C 6V-8197 Bolt 2 Start By:
Remove the main drive shaft. Refer to Disassembly and Assembly, "Main Drive Shaft - Remove and Install".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Remove the floorplate and the floor mat.
Drain the oil from the torque converter into a suitable container for storage or disposal.
Illustration 1 g01196989
Disconnect hose assemblies (1) and (2) from the torque converter and reposition.
Illustration 2 g01197089
Disconnect harness assembly (3) and the mounting brackets from the torque converter. Reposition harness assembly (3).
Illustration 3 g01197090
Remove bolts (4) and reposition guard assembly (5).
Illustration 4 g01197091
Remove bolts (6) and reposition bracket assembly (7).
Illustration 5 g01197095
Disconnect hose assemblies (8), (9), (10), and (11) from the torque converter.
Illustration 6 g01197097
Remove tube assembly (12) and (13).
Illustration 7 g01197099
Remove elbow (14).
Illustration 8 g01197101
Illustration 9 g01197102
Attach Tooling (A) and a suitable lifting device to the cab. Attach Tooling (B) and a suitable lifting device to torque converter (15). The weight of torque converter (15) is approximately 159 kg (350 lb). Remove bolts (16).
Illustration 10 g01197158
Use Tooling (C) to separate torque converter (15) from the engine. Remove torque converter (15). Remove O-ring seal (17).