CABLE A 0537957 - Caterpillar

Illustration 2 g03861002
(C) 280-8618 Hammer
Remove the hammer (C) from the window frame.
Removed the existing window from the machine.
Illustration 3 g03857480
The 371-6090 Door Window Gp (9)
( 7) 345-3155 Seal
(A) Seal corner (45° angle)
(B) Seal corner (45° angle)
Install the door seal (7) as shown in Illustration 3. Begin in one corner (A) and install the seal around the top of the frame to the opposite corner (B). Cut corners to a 45° angle. Install remaining length of seal (7) to bottom of frame. Cut the seal at each corner to a 45° angle, making sure that corners (A) and (B) fit as tightly as possible.
Illustration 4 g03857324
The 371-6090 Door Window Gp (9)
( 5) 9X-2044 Screw
(9) 371-6090 Door Window Gp
(11) 382-9160 Plate As
(12) 388-4274 Plate As
Using two screws (5) attach plate assembly (12) to door window group (9). Using two screws (5) attach plate assembly (11) to door window group (9)
Illustration 5 g03857329
The 371-6090 Door Window Gp (9)
( 5) 9X-2044 Screw
(9) 371-6090 Door Window Gp
(10) 382-9155 Hinge As
Using six screws (5) hand tighten two hinge assemblies (10) to door window group (9).
Illustration 6 g03856561
The 371-6090 Door Window Gp (9)
( 2) 8T-4137 Bolt
(3) 8T-4121 Hard Washer
(9) 371-6090 Door Window Gp
(10) 382-9155 Hinge As
Using four bolts (3) and four washers (2), secure two hinges assemblies (10) to the door window group (9). Tighten six screws installed in Step 6
Illustration 7 g03857164
Right-hand side of machine cab
(9) 371-6090 Door Window Gp
(10) 382-9155 Hinge As
Using an appropriate lifting devise position the door window group (9) so that the hinge assemblies (10) align with the threaded inserts (C).
Illustration 8 g03857166
Right-hand side of machine cab
(4) 8T-4137 Bolt
(9) 371-6090 Door Window Gp
Using six screws (4) secure the door window group (9) to the door frame.
Illustration 9 g03861055
(1) 5P-4116 Hard Washer
(6) 9X-2616 Screw
Using two Screws (6) and three washers (1), attach the latch assembly to the right-hand window frame. Be sure that the connector ring from the lanyard on the latch assembly is between the washer (1) and the bracket.
Illustration 10 g03858371
Clean all dirt and debris from the right-hand rear cab pillar. Attach the film (8) to the right-hand rear cab pillar near the window latch.
Illustration 11 g03858440
Using retained hardware and mirror install right-hand side mirror.