CABLE A 0539091 - Caterpillar

Illustration 50 g06122497
(14) 8T-4121 Hard Washer
(16) 8T-4956 Bolt
(57) 8T-4196 Bolt
(62) 319-6667 Tube As
(63) 387-4641 Tube As
(64) 387-4642 Hose As
(65) 8C-3206 Half Flange
(66) 5H-4019 Cover
(67) 4J-0520 O-Ring Seal
(68) 7X-3392 Hard Washer
(69) 197-3295 Half Flange
(70) 5H-4020 Cover
(71) 4J-0522 O-Ring Seal
Secure four tube assemblies using four O-ring seals (71), four covers (70), eight half flanges (69), sixteen hard washers (68), and sixteen bolts (16).
Illustration 51 g06321548
(14) 8T-4121 Hard Washer
(16) 8T-4956 Bolt
(57) 8T-4196 Bolt
(65) 8C-3206 Half Flange
(67) 4J-0520 O-Ring Seal
(68) 7X-3392 Hard Washer
(69) 197-3295 Half Flange
(71) 4J-0522 O-Ring Seal
(72) 387-4637 Hose As - For Standard Lift
(73) 387-4640 Hose As - For Standard Lift
(B) 383-4354 Hose As - For High Lift - Upper Hose
(E) 383-4356 Hose As - For High Lift Lower Hose
Connect one end of hose assembly (72) or (B) using two O-ring seal (67), four half flanges (65), eight hard washers (14), and eight bolts (57).Note: Install bottom hoses first.
Connect other end of hose assemblies (72) or (B) using two O-ring seal (71), four half flanges (69), eight hard washers (14), and eight bolts (16).
Connect one end of hose assemblies (73) or (E) using two O-ring seal (67), four half flanges (65), eight hard washers (14), and eight bolts (57).
Connect other end of hose assemblies (73) or (E) using two O-ring seal (67), four half flanges (65), eight hard washers (14), and eight bolts (57).Installation of Front Guard Group
Table 13
Required Parts List
Item Qty Part Number Description
46 6 8T-4136 Bolt
47 6 7X-7729 Washer
48 4 134-5245 Bolt
49 4 505-7955 Hard Washer
50 1 501-6993 Loader Frame Guard
Illustration 52 g06122470
(46) 8T-4136 Bolt
(47) 7X-7729 Washer
(48) 134-5245 Bolt
(49) 505-7955 Hard Washer
(50) 501-6993 Loader Frame Guard
Install loader frame guard (50) onto the NEEF using four bolts (48) and four washers (49).
Secure loader frame guard (50) using four bolts (46) and four washers (47).Software Configuration
Note: This machine feature can be configured and must be activated with product software programming system or service tool.
Use Caterpillar Electronic Technician (CAT ET) and select the Transmission Electronic Control Module (ECM).
Select "Service" from the menu.
Select "Configuration" from the menu.
Double-click the desired feature on the "Configuration" screen to change.
Enable the "Configuration" to "3 - Function Lever Control" and calibrate the valve and controllers in the cab.