CABLE AS-PARKING BRAKE CONTROL 1479654 - Caterpillar

Remove Magneto Drive
start by:a) remove magnetob) remove service meter1. Remove nuts (1), washers, cover (2) and gasket from the front housing.2. Remove bolt (3) and washer.3. Put tooling (A) in position on drive gear (4). Loosen drive gear (4) from the magneto drive sleeve. Remove tooling (A).4. Disconnect oil supply line (7) from magneto drive (6).5. Remove nuts (5) and washers that hold magneto drive (6) in place. Remove magneto drive. Install Magneto Drive
1. Put magneto drive (1) in position on the front housing plate.2. Install washers and nuts (2) that hold magneto drive in place.3. Connect oil supply line (3) to the magneto drive.4. Install washer and bolt (4). Tighten bolt (4) to a torque of 110 5 lb.ft. (149 7 N m).5. Install gasket and cover (5) on the front housing. Tighten the nuts that hold the cover in place to a torque of 20 5 lb.ft. (25 7 N m).end by:a) install service meterb) install magneto Disassemble Magneto Drive
start by:a) remove magneto drive1. Remove O-ring seal (1) and bolt (2) from magneto drive (3).2. Turn magneto drive (3) over and remove magneto drive gear assembly (5).3. Remove adapter assembly (4) and gasket from housing (6).4. Use a hammer and punch and remove taper pin (7) from magneto drive gear assembly (5).5. Put magneto drive gear assembly (5) and tooling (B) in position in a press as shown.6. Use tooling (A) and press to push shaft (8) from gear (9).7. Remove key from shaft (8). 8. Inspect bushing (11) for wear and damage. If a replacement is necessary, bushing (11) must be destroyed to be removed.9. Inspect seal (10) for wear and damage. If a replacement is necessary, seal (10) must be destroyed to be removed.10. Turn adapter assembly (4) over. Inspect bearing (12) for wear and damage. If a replacement is necessary, bearing (12) must be destroyed to be removed.11. Remove idler gear (13) from housing (6).12. Inspect bearing (14) for wear and damage. Use tooling (A) to remove if necessary. 13. Put housing (6) in position on a press.14. Install a 1/2"-20 NF × 2" bolt (15) in shaft assembly as shown.
Make sure gear on shaft assembly (17) does not make contact with the press while the shaft assembly is pushed from sleeve (16).
15. Use press to push shaft assembly (17) free of sleeve (16).16. Remove shaft assembly (17), bolt (15) and sleeve (16) from housing (6).17. Inspect bearings (18) and (19) for wear and damage. If a a replacement is necessary, bearings (18) and (19) must be destroyed to remove.Assemble Magneto Drive
Make an alignment of oil holes in bearings (1) and (2) with the oil holes in housing (3).1. If bearing (1) was removed, use tooling (A) to install the bearing even with the face of the housing.2. If bearing (2) was removed, use tooling (A) to install the bearing to the bottom of the bearing bore.3. Put shaft assembly (5) into position in